Axminster MCB100A User Manual - Page 11

Browse online or download pdf User Manual for Saw Axminster MCB100A. Axminster MCB100A 20 pages. 4" metal cutting bandsaw

Print Page

! WARNING

Disconnect machine from the power

source!

No mater when, where, or how. Pay

extra attention to the saw during it in

transportation, operation, maintenance,

or adjustment.

Failure to comply may cause serious

injury!

CHANGING BLADE

1. Raise this saw head up-to 90 degree by

lifting up knob (A) in Fig. 5 a little bit to

release the lock-pin, and slide it into the

slot that is made for setting the saw arm

in vertical position.

2. Remove this blade guards (B), and blade

cover by loosening two bolts (C) on the

saw frame.

3. Push tension handle (D). Counter wise to

let the blade slip off.

4. Remove blade from both wheels (E), and

blade guide bearing (F).

5. Place a new blade on the flanges of

wheels but not too tight, twist blade

slightly and let it slip into between each of

guide bearings. Make sure the teeth of

blade face down toward the bed

6. Fasten the tension handle clockwise

move the blade by pulling it down with

one hand and it will be tracked onto

wheels properly.

7. Replace blade cover (G) and guards. And

start the machine to see that the blade

runs properly.

Fig. 5