Axminster UE-127DV1 User Manual - Page 9
Browse online or download pdf User Manual for Saw Axminster UE-127DV1. Axminster UE-127DV1 16 pages. Portable band saw
Print Page
6. Description and Characteristics
1.
This 127DV1 portable band saw is made
as light as 24 kg by weight for your fitness
to transport to any worksites.
2.
This machine frame is cast by the
aluminum. The base formed by the steel so
that body construction becomes stronger
and smoother.
3.
During operation, the noise level of this
machine is about 60 db, which is much less
than any of the other band saws, and of
course, it can present a comfortable
working environment.
4.
This machine is made ready for the blade
tension adjustment by holding the handle to
give a little turn for the tension increasing,
or decreasing as you wish during the
period of blade replacement or machine in
operation. Also attached compression
spring that for reducing vibration that is
from a defective work piece popping while
machine is running. It permits the blade to
be used much longer.
5.
The drive of this machine is through gear
transmission that gives steadier, stronger,
and smoother cuts superior to any of pulley
drive band saws, and make less trouble
after service. Note: If anything unusual
happens on your gear transmission system,
do not try to fix or restore it personally.
Send it back to your dealer for check-up or
repair. Failure to comply can result in
machine damage.
6.
The machine combines miter, and
horizontal cutting and is designed for full
efficiency and operator convenience in
each position.
SHUT OFF THE POWER SOURCE ALL THE
TIME, BEFORE THIS MACHINE IS IN
MAINTENANCE, OPERATION, ADJUSTMENT,
OR REPAIRMENT.
Disconnect machine from the power source!
No matter when, where, or how. Pay extra
attention to the saw during it in transportation,
operation, maintenance, or adjustment.
Failure to comply may cause serious injury!
WARNING
WARNING
7. Operating
Information before Operation
Be sure the blade isn't in contact with the work
when the motor is started.
Run the motor allow the saw to come to full
speed. Begin the cut by letting the head down
slowly onto the work.
DO NOT DROP. Let the weight of the saw
provide the cutting force or use the trigger switch
handle operating by hand.
Press green button down (Fig. 5) for auto cutting,
feed rate by bow weight, the trigger switch
(FIG.6) for manual cutting.
Finished cutting or stop the cutting by press
down the red button or switch off the trigger
switch.
ON/OFF switch
While cutting, If any emergency event need to
stop the machine immediately, Push the red
button to stop the machine.
Emergency stop
- 7 -
Fig. 5
Trigger switch
Fig. 6