Axminster ujk 106843 Manual - Page 18

Browse online or download pdf Manual for Tools Axminster ujk 106843. Axminster ujk 106843 20 pages. Universal dovetail jig

Print Page

CORNER DOVETAIL REBATES

Fig 03-04

3) Mark an 8mm line from the top edge on the side of

the vertical board, see fig 05 then load in the vertical

up against the left hand side stop and up against the

underside of the comb to meet the edge of the

horizontal board, see fig 06-07. Use the wider part of

the magnetic set gauge to ensure that the joint line is

central to the comb slot, see fig 08. Use the comb

adjuster knobs to align & adjust, see fig 08.

Fig 05-06-07-08

4) Plunge the cutter down through the comb slot so

that the tip of the cutter just meets the marked line,

see fig 09. Attach the magnetic extraction at the right

hand end of the support bar, see fig 10.

Fig 09-10

5) Start the cut at the right hand side of the jig

moving the router from right to left in a slow, steady,

continuous motion, see fig 11 DO NOT LIFT THE

ROUTER AT ANY TIME DURING A CUT, see fig 12-13.

Fig 11-12-13

Single pass 15mm board thickness, 5/8" guide bush -

The process to achieve a good corner edge alignment on

a 15mm board is as previously described in steps 1 to 5

apart from the use of the ⅝"(15.9mm) guide bush & the

direction of travel with the router, 14-15-16-17-18.

Fig 14-15-16-17-18

Direction of travel - clockwise