Axon TASER User Manual - Page 13

Browse online or download pdf User Manual for Digital Camera Axon TASER. Axon TASER 16 pages. Body camera

Print Page

Radio Waves

Changes or modifications to the equipment not expressly approved by the manufacturer could void the product

warranty and the user's authority to operate the equipment.

Your wireless device is a radio transmitter and receiver. It is designed and manufactured not to exceed the

emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission (FCC)

of the U.S. Government. These limits are part of comprehensive guidelines and establish permitted levels of RF

energy for the general population. The guidelines are based on standards that were developed by independent

scientific organizations through periodic and thorough evaluation of scientific studies. The standards include

a substantial safety margin designed to assure the safety of all persons, regardless of age and health. Before a

device model is available for sale to the public, it must be tested and certified to the FCC that it does not exceed

the limit established by the government‐adopted requirement for safe exposure. This equipment has been tested

and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult TASER International Customer Service for help.

FCC/IC NOTICE: This device meets the body worn human exposure limits found in OET Bulletin 65, 2001, and

ANSI/IEEE C95.1, 1992. Proper operation of this equipment according to the instructions found in this guide will

result in exposure substantially below the FCC's recommended limits. To comply with the FCC and ANSI C95.1 RF

exposure limits, this device has been tested for compliance with FCC RF Exposure limits in the typical configuration.

The radiated output power of this wireless device is far below the FCC radio frequency exposure limits.

Section 7.1.3 of RSS-GEN

This Device complies with Industry Canada License-exempt RSS standard(s). Operation is subject to the following

two conditions: 1) this device may not cause interference, and 2) this device must accept any interference,

including interference that may cause undesired operation of the device.

Cet appareil est conforme aux normes d'exemption de licence RSS d'Industrie Canada. Son utilisation est soumise

aux conditions suivantes : 1) cet appareil ne doit pas causer de brouillage, et 2) doit accepter tout brouillage, y

compris le brouillage pouvant entraîner un fonctionnement indésirable.

Chapter 6

Troubleshooting