Alphasonik PFZ680E Owner's Manual - Page 8

Browse online or download pdf Owner's Manual for Speaker System Alphasonik PFZ680E. Alphasonik PFZ680E 16 pages. Full range speaker systems

Print Page
I
N
S
is turned off while connecting the speaker terminals. Turn on the
T
various components and slowly advance the volume.
A
L
Remember to check and recheck all connections to insure
L
proper use.
A
T
I
with your new speaker system. Thinner gauge wire may easily
O
N
be severed and can cause damage to your system should any
bare wire come in contact with the vehicle's chassis.
C
O
N
and connecting your new Alphasonik speakers. Failure to do so
T
could result in damaging the speaker beyond repair.
I
N
insulated terminals ending at the speakers. This will insure a
U
E
good contact with the speaker.
D
speaker lead, do so at the opposite end of the insulated
terminals or the bare end.
leads are color-coded for negative and positive. Be sure that the
leads are connected to the correct terminal of the speaker.
wire-to-wire connections should be soldered and insulated with
heat shrink or electrician's tape. Under no circumstances should
you leave any bare wires uncovered, as this can and will lead to
the damage of your speakers.
right amount of slack in the connecting wire so it does not get
crimped or torn when the door is opened and closed. Avoid
areas of the door jam that pinch, this will cause damage to the
speaker over long-term use.
the opposite end to the source unit or amplifier. Again, be sure
to observe the correct polarity. Solder and wrap all stripped
connections.
7
Make sure your source unit (Cassette, CD, DAT, DVD, etc)
1.
Alphasonik recommends using at least 18-gauge wire
2. Make sure that your audio system is off while installing
3. Be sure to route the wires to the speakers with the
4. Be sure the polarity is correct at all times. The speaker
5.
To insure long-term reliability, all bare wires and
6.
When mounting in a door, it is imperative to have the
7. Once the speaker wiring is completed you can connect
If you need to shorten the