AccuPower IQ-338 User Manual - Page 4

Browse online or download pdf User Manual for Battery Charger AccuPower IQ-338. AccuPower IQ-338 7 pages.
Also for AccuPower IQ-338: User Manual (6 pages)

Print Page

You can choose the following programs:

Charge

In this program you can charge the inserted batteries.

Charge Test

With „Charge Test" program you can measure the charged capacity of the batteries. The

charger discharges the batteries in the first step, during the discharge process the LC

Display starts to count the discharged capacity. After that, the battery gets charged

completely in the 2

charger's memory and can be retrieved after finish. So this test consists of the following

steps:

1) Discharge (The capacity gets measured and stored and is available after end of the

test)

2) Charge (The capacity gets measured and stored and is also available after end of

the test)

If the channel button gets pressed for the first time, only the display lights up. After

pressing it again, the shown capacity on the display switches between the measured

charging and discharging capacity. Which one of them is displayed, is symbolized by

the label "CH" for charged and "DISCH" for discharged value over the unit "mAh". Also

the current is changing depending on the chosen current during the Charge Test. The

used charging current is symbolized by „CH-CURRENT" as well as the discharging

current by „DISCH-CURRENT".

Generally, the charging capacity value can be different to the discharging capacity

value because of efficiency of the chemical reaction in the batteries.

This mode can also be used very well for refreshing batteries.

Discharge Test

The difference of „Discharge Test" program to „Charge Test" program is, that the batteries

will get charged in the 1

This happens in the 2

completely again in the 3

1) Charge (This capacity gets measured and displayed but not stored till the end)

2) Discharge (The capacity gets measured and stored and is available after end of the

test)

3) Charge (The capacity gets measured and stored and is also available after end of

the test)

User Manual

step. Both capacity values (discharged as charged) are stored in the

step so that it can be discharged afterwards with the full capacity.

step. To complete the process, the battery gets charged

step. The process is as follows:

4/7

Update version-V2