Axor Terrano 37030XX1 Installation Instructions / Warranty - Page 4

Browse online or download pdf Installation Instructions / Warranty for Plumbing Product Axor Terrano 37030XX1. Axor Terrano 37030XX1 8 pages. Axor - hansgrohe, inc. widespread lavatory faucet installation instructions / warranty

Print Page
Assembly
1. Flush pipe lines thoroughly.
2. Place the mixer including the sealing washer in
position on the basin / bidet.
3. Slip the fixation piece including the washer over
the threaded pin and tighten the nut.
4. Connect the supply pipes to the supply valves:
hot-left; cold-right.
5. Connect the pop-up rod to the pop-up waste
assembly.
Large differences in pressure between the hot and
cold water supply should be balanced.
Technical Data
Operating pressure:
Recommended operating press.:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Hole size in deck:
Minimum:
Maximum:
Spare parts (see page 3)
1
Handle for cold/hot water
2
Screw cover cold/hot water
3
Spout lav mixer
4
Aerator lav mixer
5
Stop unit
6
Lift rod
7
Lift rod extension
8
Fixation set
9
Tube
10 Spout bidet mixer
11 Aerator bidet mixer
XXX = Colors
000 chrome
810 satinox
®
4
Install the pop-up drain
•
•
•
•
•
•
•
max. 147 psi
•
14.7 - 72.5 psi
•
232 psi
max. 176° F
149° F
•
•
1 1/4"
1 5/8"
•
37299XXX
96481XXX
96521XXX
96336XXX
94149000
94006XXX
96617000
96016000
30622210
96522XXX
94005XXX
swivel connector
Remove the plunger assembly.
Unscrew the drain outlet flange from the tee.
Unscrew the tailpiece from the tee. Wrap
the threads with plumbers' thread tape and
replace.
Install the white, flexible sealing gasket to the
flange. Sit it in the sink outlet.
From under the sink, install the black mack
gasket, white friction ring , and retainer nut to
the flange. Do not tighten the nut against the
bottom of the sink at this time.
Thread the tee and tailpiece to the flange. The
pivot must face the faucet. If necessary, turn the
drain assembly.
Tighten the retainer nut.
Sit the plunger assembly in the drain.
Install the horizontal rod so that the end goes
through the loop in the bottom of the height
adjuster.
Install and hand tighten the pivot ball nut.
Attach the swivel connector to the end of the
horizontal rod.
Attach the swivel connector to the end of the
vertical rod.
Position as desired, and tighten
with a small, flathead screwdriver.
plunger
height adjuster
drain outlet flange
sealing gasket
pivot ball nut
horizontal rod
mack gasket
friction ring
retainer nut
tee