CIPTON CPTN4003 Instruction Manual - Page 3

Browse online or download pdf Instruction Manual for Sports & Outdoors CIPTON CPTN4003. CIPTON CPTN4003 8 pages. Led light up basketball kit

In ating the Basketball
1. Attach an in ation needle onto the included ball pump.
2. Carefully stick the in ation needle into the valve on the ball.
3. Pull and push the handle on the back of the ball pump to pump up the ball to a PSI
of between 7 and 9. Be careful not to over-in ate the ball, as this can pop it.
4. When nished, remove the in ation needle from the ball, and store the ball pump
away.
Basketball LED Setup
• The ball comes with batteries already installed. Pull the tab marked "PULL" to remove
the spacer insulating the batteries.
• To activate the lights, bounce the ball. The lights are impact-activated.
• If the spacer is broken and cannot be pulled out, or if the ball does not light up after
the spacer is removed, try following the steps in the Replacing the Batteries section
below to re-install the light unit or replace the batteries.
Replacing the Basketball Batteries
CAUTION: Do not sure a sharp tool to open the cap. It is recommended to use a key.
These procedures should be done carefully, under adult supervision ONLY.
Keep all batteries, wrenches, plastic bags and other accessories away from babies,
children and pets. They are NOT toys. They can cause injury, su ocation, poisoning or
other dangers.
(Continued on the next page)
Using the Basketball