Arcam fmj D33 User Manual - Page 9

Browse online or download pdf User Manual for Media Converter Arcam fmj D33. Arcam fmj D33 13 pages. Digital to analogue converter

Print Page

remote

control

The D33 is supplied with the Cr107 remote control.

using the remote control

Please keep in mind the following when using the

remote control:

Ensure there are no obstacles between the

remote control and the remote sensor on the

front panel. The remote has a range of about 5

metres. (If the remote sensor is obscured, the

Ir in remote control input jack on the rear

panel is available. Please consult your dealer

for further information.)

remote operation may become unreliable if

strong sunlight or fluorescent light is shining

on the remote sensor of the unit.

replace the batteries when you notice a

reduction in the operating range of the

remote control.

inserting batteries into the

remote control

Open the battery compartment by sliding

open the battery cover.

Insert two ' A AA' batteries into the battery

compartment – facing opposite directions, as

in the diagram and the battery compartment

indication.

Slide the battery cover back into place.

notes on batteries:

Incorrect use of batteries can result in hazards

such as leakage and bursting.

Do not mix old and new batteries together.

Do not use non-identical batteries together –

although they may look similar, different batteries

may have different voltages.

Ensure the plus (+) and minus (-) ends of each

battery match the indications in the battery

compartment.

remove batteries from equipment that is not

going to be used for a month or more.

When disposing of used batteries, please comply

with governmental or local regulations that apply

in your country or area.

e-9

alternative code selection

In the rare situation that the Cr107 remote control

happens to operate another device in the room, the

Ir code can be changed to an alternative rC5 system

number.

To change the remote control to the alternate code:

1. Press and hold the

and

keys for 6 seconds until

the LED at the top of the remote remains lit.

2. Press

to select the alternative Ir codes (rC5

OpT2

system code 28) or press

to select the

OpT1

original code set (rC5 system code 27).

If no key is pressed within 10 seconds the remote will

return to normal operation.

note: the selection of the alternate codes is reset when

batteries are changed.

In addition to changing the remote handset, the D33

unit must also be reconfigured to respond to the

alternate codes. With the unit powered on, press the

and

buttons simultaneously. The

OpTICAl 1

AES/Ebu

LED will flash to indicate remote code selection.

FIlTER

Press the

button to toggle between the normal Ir

FIlTER

codes (

LED flashing) and the alternative codes

FIlTER 1

(

LED flashing). Press any other key to exit the

FIlTER 2

code selection mode.