Creator CRT-531 Series Product Specification - Page 8
Browse online or download pdf Product Specification for Dispenser Creator CRT-531 Series. Creator CRT-531 Series 13 pages. Card dispenser
Print Page
SPECIFICATION
4.4 Extend CRT Command
Command +
Parameter
"FC"+ Position
"CS"+ Position
"IN"+ Parameter
"SI"
to RF command returned)
Note ： （ 1 ） " 4"is the position for card pre-dispense, program will execute "pre-dispense"
automatically(Except press "Reset" keystoke on the dispenser by hand); Execute "FC+4", no any
reaction for this command, and this will cause unpredictable damage, so please don't use this
command in a hurry.
(2)The operation of checking status for "SI" inserting card from dispenser mouth is similar to
"RF" and "AP". The parameter of command returned with 1byte is same as the "IN"parameter.
(3) "IN" is a operation command for EEPRON. The setting status will not be affected even if
it is power on or reset, that means the last setting is still valid when power on. And It is defaulted
that the card is captured to the error card bin when ex-work.
4.5 Specification of photoelectricity sensor and card stop location
4.3.1 Definition of graph
photoelectricity sensor
n
4.5.2 Sketch map of card stop location and photoelectricity sensor
Card Dispenser
Return
<06H>
， 1 ， 2 ， 3 ， 4 ， 5 ， 6} parameter:
0x30,0x34,0x33,0x32,0x31,0x36,0x37｝
<06H>
<06H>
SI +Parameter(similar
Card Stop Location
photoelectricity sensor preserved
n
Model No.
CRT-531
Date
2010-2-1
Ver.
Page
Comment
Card stop on the specified
Set up Baud rate.(0-5,
indicate 1200BPS-38400BPS)
Setting
of
card
dispenser mouth:
Parameter
=0x30 Prohibit cards in
=0x31 Allow cards into error card bin
=0x32
Allow
cards
read/write position (I.e. card stop
location 2)
Check
the
setting
inserted from the dispenser mouth
3.0
8/13
position ，
inserted
from
into
card
status
of
card