Axxess AX-ADFD01 Installation Instructions Manual - Page 4
Browse online or download pdf Installation Instructions Manual for Automobile Accessories Axxess AX-ADFD01. Axxess AX-ADFD01 16 pages. Data interface for ford
Print Page
Attention! This interface will work with models that are either non-amplified, or amplified.
Please follow the instructions carefully for your model vehicle. Failure to do so will result in
either no sound, or low sound. If you are unsure if your vehicle is factory amplified or not, please
contact your local dealership.
For models with a Sony/THX amplifier:
From the 16-pin harness with stripped leads to the aftermarket radio (harness included with interface):
• Connect the Red wire to the accessory wire.
Note: If installing either an ASWC-1 or AX-LCD (both sold separately), connect the (2) Red
wires on the AX-ADFD01 harness as well.
• Connect the Blue/White wire to the amp turn on wire. This wire must be connected to
hear sound from the factory amplifier.
Note: If the vehicle is equipped with NAV, there will be an amp turn-on wire on the AX-
ADFD01 harness to connect as well.
• If the aftermarket radio has an illumination wire, connect the Orange/White wire to it.
• If the aftermarket radio has a mute wire and the vehicle is equipped with SYNC, connect
the Brown wire to it. If the mute wire is not connected, the radio will turn off when SYNC
is activated.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
4
CONNECTIONS TO BE MADE
The following (3) wires are only for multimedia/navigation radios that require these wires.
From the AX-ADFD01 harness to the aftermarket radio:
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative output.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• If installing either an ASWC-1 or AX-LCD (both sold separately), connect the (2) Red wires
to accessory power.
• Connect the Blue wire to the power antenna wire.
• For NAV models only: Connect the Blue/White wire with a red connector to the amp turn
on wire. This wire must be connected to hear sound from the factory amplifier.
• If the vehicle is equipped with satellite radio or SYNC, and desired to be retained, connect
the Red and White RCA jacks labeled "RSE/SYNC/SAT" to the audio AUX-IN jacks.
Note: Most Ford radios have satellite radio built into the radio, so this feature is lost if so.
Continued on the next page