Axxess AX-CH013-SWC Installation Instructions Manual - Page 5
Browse online or download pdf Installation Instructions Manual for Recording Equipment Axxess AX-CH013-SWC. Axxess AX-CH013-SWC 12 pages. Chrysler data interface with swc2004-up
Print Page
CONNECTIONS TO BE MADE
3.5mm jack steering wheel control retention:
• The 3.5mm jack is to be used to retain audio controls on the steering wheel.
•
For the radios listed below, connect the included female 3.5mm connector with stripped leads, to the
male 3.5mm SWC jack from the AX-CH013-SWC. Any remaining wires tape off and disregard.
•
Eclipse: Connect the steering wheel control wire, normally Brown, to the Brown/White wire of
the connector. Then connect the remaining steering wheel control wire, normally Brown/White,
to the Brown wire of the connector .
•
Metra OE: Connect the steering wheel control Key 1 wire (Gray) to the Brown wire.
•
Kenwood or select JVC with a steering wheel control wire: Connect the Blue/Yellow wire to the
Brown wire.
Note: If your Kenwood radio auto detects as a JVC, manually set the radio type to Kenwood. See
the instructions under changing radio type.
•
XITE: Connect the steering wheel control SWC-2 wire from the radio to the Brown wire.
•
Parrot Asteroid Smart or Tablet: Connect the 3.5mm jack into the AX-SWC-PARROT (sold separately),
and then connect the 4-pin connector from the AX-SWC-PARROT into the radio.
Note: The radio must be updated to rev. 2.1.4 or higher software.
•
Universal "2 or 3 wire" radio: Connect the steering wheel control wire, referred to as Key-A or
SWC-1, to the Brown wire of the connector. Then connect the remaining steering wheel control wire,
referred to as Key-B or SWC-2, to the Brown/White wire of the connector. If the radio comes with a
third wire for ground, disregard this wire
Note: After the interface has been programmed to the vehicle, refer to the manual provided with
the radio for assigning the SWC buttons. Contact the radio manufacturer for more information.
•
For all other radios: Connect the 3.5mm jack from the LD-BX-CH3 or LD-BX-CH4 harness, into the jack
on the aftermarket radio designated for an external steering wheel control interface. Please refer to
the aftermarket radios manual if in doubt as to where the 3.5mm jack goes to.
(CONT)
.
INSTALLING THE AX-CH013-SWC
With the key in the off position:
• Connect the 16-pin harness with stripped leads, and the AX-CH013-SWC harness,
into the interface.
Attention! Do not connect the AX-CH013-SWC harness to the wiring harness in the vehicle just yet.
Attention! If retaining steering wheel controls, ensure that the jack/wire is connected to
the radio before proceeding. If this step is skipped, the interface will need to be reset for
the steering wheel controls to function.
REV. 7/25/2018 INSTAX-CH013-SWC
5