DigiDesign VENUE XO16 Manual - Page 8

Browse online or download pdf Manual for Recording Equipment DigiDesign VENUE XO16. DigiDesign VENUE XO16 12 pages. Analog/digital output card for venue mix rack and venue sc48

Print Page

On Mix Rack's back panel, locate output slot E.

If you are installing the XO16 Card in a slot with a card

slot cover, you must first remove the card slot cover.

Mix Rack back panel

Remove the card from its packing material. Hold the card by

its edges.

Gently slide the card into the output slot.

When the card is seated in its slot, use the captive thumb-

screws to secure the card to Mix Rack's chassis in the back of

Mix Rack.

Secure the card to the front panel of Mix Rack using the four

mounting screws you removed earlier.

XO16 Analog/Digital Output Card

Find the Hub48 Board ribbon cable that corresponds to the

output slot in which you have installed the XO16 Card. The

Hub48 board's five ribbon cables connect to the Input and

Output Expansion Cards.

Do not remove or re-seat the ribbon cable connections on

the Hub48 Board while the board is installed in the Mix

Rack. This may cause excessive flexing of the Hub48 Board.

If necessary, disconnect the Hub48 and all input and out-

put card ribbon connections, and remove the entire assem-

bly from the rack prior to changing connections.

Output

slot E

Detail of back of Mix Rack, the Hub48 Board, and the ribbon cables

Mix Rack contains 5 ribbon cables that connect to the input

and output cards. The top two ribbon cables connect to the

output cards installed in Output Slots D and E.

Connect the ribbon cable to the card socket on the XO16

card.

Make sure the pins on the socket are correctly aligned with the

ribbon cable connector. Secure the connection by moving the

retaining clips on each side of the socket connector inward.

Check to make sure the ribbon cable is connected securely.

A properly connected Expansion Card

Connects to card

in Output Slot E

Connects to card

in Output Slot D

Hub48 Board