EPSON Stylus Photo 785EPX
4. Lift the cartridge out of the printer and dispose of it
carefully.
Keep ink cartridges out of the reach of children and do
not drink the ink.
If ink gets on your hands, wash them thoroughly with
soap and water. If ink gets in your eyes, flush them
thoroughly with water.
5. Unwrap the new ink cartridge. Then remove only the yellow
tape seal on top.
black cartridge
You must remove the yellow tape from the top of the
cartridge or you will permanently damage it. Don't try to
remove the clear seal underneath the cartridge.
Don't touch the green circuit board on the back of the
cartridge; you may inhibit normal operation and printing.
6. Tilt the new cartridge toward you slightly as you insert it.
hooks
EPSON Stylus Photo 785EPX
8 -
color cartridge
Don't place the cartridge
under the hooks; you
may damage the clamp
when you close it.
Lower the cartridge so that the tabs rest on the hooks as
shown:
7. Press down firmly on the ink cartridge clamp until it snaps
in place.
8. If you need to replace the other ink cartridge, repeat steps 3
through 7 before continuing with step 9.
9. Press the e ink cartridge replacement button and close the
printer cover. The printer begins charging the ink delivery
system.
The
Processing
Charging takes about one minute. When it's finished, the
light stops flashing and stays on, and the
Processing
b
error light goes out.
Never turn off the printer while the Processing light is
flashing, unless the printer hasn't moved or made noise
for more than 5 minutes.
Cleaning the Print Head
If your printouts are unexpectedly light or faint, or dots or
lines are missing from the image, you may need to clean the
print head. This unclogs the nozzles so they can deliver ink
properly. Print head cleaning uses ink, so clean it only if
quality declines.
This section explains how to clean the print head using the
Head Cleaning utility. This is the recommended method
when the printer is connected directly to your computer (not
over a network).
You can also clean the print head by holding down the
b maintenance button on the printer's control panel for three
seconds when the b error light is off. See your on-screen
Reference Guide for detailed instructions.
When you don't turn on your printer for a long time, the
print quality can decline. It's a good idea to turn on your
printer at least once a month to maintain good print
quality.
4/01
light flashes, and the printer makes noise.
Print Page