Epson ActionLaser 1600 User Manual - Page 5

Browse online or download pdf User Manual for Printer Epson ActionLaser 1600. Epson ActionLaser 1600 10 pages. Epson actionlaser 1600: quick start
Also for Epson ActionLaser 1600: Read This First Manual (26 pages), Product Specification (2 pages)

Print Page

To install a SIMM:

1. Hold the SIMM as shown below and insert it into the slot

at an angle as shown below. Make sure the pin number of

both the slot and the SIMM matches, showing 1 or 72.

2. Press the SIMM in firmly, in the direction shown in the

illustration, until it snaps into the notch of the connector.

Do not apply too much force.

3. Reinstall the controller board as shown in the next section.

Reinserting the controller board

1. Hold the controller board level and fit its right edge into

the right groove inside the board slot. Then gently tit its

left edge into the left groove.

2. Slide the controller board into the printer until it locks in

place. If the controller board does not fit smoothly into the

printer, do not force it. Remove it and make sure the

edges tit properly into the grooves inside the slot.

3. Secure the board with the three silver screws you removed

earlier.

Laser Printers

Attach the interface board cover with the two screws you

removed earlier.

Note:

Do not attach the interface cover if an optional interface is

installed.

Reconnect any interface cables you removed

Insert the interface cable or cables into the U-shaped part of

one cable clip. Lift the left side of the printer up slightly.

Then hook the short lip of the clip into the forward slot

and push the bottom of the clip under the printer until it

clicks in place. Repeat this procedure with the second clip

and insert it into the back slot.

Be sure the power is turned off, then plug the power cord

into an electrical outlet.

Checking the memory

Turn on the printer. When the RAM Check message appears,

make sure the printer displays the total amount of RAM that

you now have installed, including the 2MB of standard

memory.

If an incorrect amount appears, turn off the printer and

remove the controller board. Make sure you installed each

SIMM in the correct direction and that it is fully seated. If the

RAM Check message is still incorrect, contact your dealer or

a qualified service person for assistance.

Option Specifications

Face-up output tray

Dimensions and

weight:

Paper eject

capacity :

5/10/94

EPSON ActionLaser 1600

Without the printer:

Height

47 mm (1.7 inches)

Width

251 mm (9.9 inches)

Depth

275 mm (10.8 inches)

Weight

0.1 kg (0.2 lb)

20 sheets (80 g/ m

)

AL1600-5