Epson ActionLaser 1600 User Manual - Page 8
Browse online or download pdf User Manual for Printer Epson ActionLaser 1600. Epson ActionLaser 1600 10 pages. Epson actionlaser 1600: quick start
Also for Epson ActionLaser 1600: Read This First Manual (26 pages), Product Specification (2 pages)
Print Page
EPSON ActionLaser 1600
REMOVE CART
You may have inserted an optional font cartridge while the
Form Feed light was on. To correct the error, remove the
cartridge, reinsert it into the slot, and press the Continue
button.
The printer's current interface port has been reset and the
buffer cleared. However, other interface ports are still active
and retain their settings or data.
RESET ALL
All printer settings have been reset to the specified settings.
RESET TO SAVE
You have changed a SelecType setting but the new setting
has not yet been enabled. To enable the new setting, hold
down the Alt button and press Reset.
SELF TEST
The printer is performing an internal check cycle. Please wait
a few seconds until the check is finished.
SERVICE REQ.XXXX
A controller error or a print engine error has been detected.
Write down the error number listed on the display and turn
off the printer. Wait at least five seconds and then turn it
back on. If the error message still appears, turn off the
printer, unplug the power cord, and contact a qualified
service person.
STANDBY
The printer is currently in a low-power state. (When the
printer is not used for 15 minutes, it enters standby mode.)
Press any button or send data to warm up the printer.
Warm-up takes approximately 30 seconds.
TONER LOW
The printer is almost out of toner. When you see this
message, you must replace the imaging cartridge soon.
TONER OUT
You must replace the imaging cartridge.
To print one additional page, press the Continue button.
WARMING UP
The printer is warming up. Warm-up takes approximately
30 seconds.
AL1600-8
Feed Jam
When the printer stops printing and the FEED JAM message
appears, follow these steps:
1. Open the paper cover. Carefully remove all the paper in the
paper tray along with any sheets that have fed part way
into the printer.
2. If the paper tears when you remove it, make sure you
remove any pieces remaining in the printer. To do this,
gently open the printer cover.
Opening the printer cover exposes the fuser, which is marked
by a CAUTION HOT SURFACE label. Be careful not to
touch the fuser.
Remove the imaging cartridge. Next remove any paper
from the paper feed path and reinsert the imaging
cartridge.
Close the printer cover.
Tap the edges of the paper stack on a flat surface and
carefully reload it into the paper tray. (Do not reload
curled or wrinkled sheets.) Close the paper cover.
The jammed page is automatically reprinted. If you did not
open the printer cover to clear the feed jam, press the
Continue button.
Paper Jam
When the printer stops printing and the PAPER JAM
message appears, follow these steps:
1. Gently open the printer cover and remove the imaging
cartridge.
Opening theprinter exposes the fuser, which is marked by a
CAUTION HOT SURFACE label. Be careful not to touch the
fuser.
5/10/94
Laser Printers