Axxion ASB-210 BT User Manual - Page 8

Browse online or download pdf User Manual for Speaker System Axxion ASB-210 BT. Axxion ASB-210 BT 16 pages. Bluetooth soundbar with usb & sd cardreader

Print Page

8. During playback, press and hold TUNING/SKIP/SEARCH buttons to search

through the current track forward or backward.

Note:

Pairing mode is canceled about 1.5 minutes.

The above are generic steps to pair a BLUETOOTH® device, for more specific

instructions on BLUETOOTH® connectivity for your device, please consult your

manufacturer's manual.

RE-CONNECT TO THE BLUETOOTH® AUDIO SOURCE DEVICE

If the device is already paired with the ASB-210 BT, but became unconnected even

with both Bluetooth® devices turned on. You can re-connect them by following steps:

1. Press and hold the PAIR button on the unit or on the remote to re-link the audio

source device. The Bluetooth® indicator will blink for about 1.5 minutes for

connecting.

2. Select ASB-210 BT on the audio source device for connecting. Bluetooth®

indicator will turn to solid blue if the ASB-210 BT and the device have been re-

connected successfully.

EQ EFFECTS

During playback, press EQ button on the remote repeatedly to cycle through the EQ

options; when your desired EQ effect shows on the screen, release the button.

FM RADIO

TUNING THE FM RADIO

1. Power on the unit, switch to FM (RADIO) mode by pressing SOURCE button

repeatedly.

2. Press the TUNING/SKIP/SEARCH buttons on the remote to fine tune radio station.

Press and hold the TUNING/SKIP/SEARCH buttons on the remote to auto search

radio station forward or backward respectively (When an available station will be

found, the unit will broadcast it immediately and the searching will be stopped).

During auto searching, press the TUNING/SKIP/SEARCH buttons on the remote to

stop the searching.

3. At radio mode, it is possible to access the frequency via numeric buttons on the

remote control. For example, press buttons 8, 9 and 8 to get to 89.8 MHz.

STORING YOUR FAVORITE RADIO STATION

1. During playback, press the MEM button on the remote for storing the current

station until a memory cell number flashes on the screen.

2. Use the CH+ or CH- buttons on the remote to select the corresponding memory

cell for storing the station.

3. Confirm your selection by pressing the MEM button on the remote.

4. During radio playback, press the CH+ or CH- buttons on the remote repeatedly to

recall the stored stations.