3
Install Photoconductor
Caution: Make sure the CX11N is turned on and you have installed all the toner
cartridges, as described in the previous section.
1
Install Photoconductor appears in the LCD screen. Lift up the scanner.
2
Lift up cover B and raise the orange lever
inside, on the right.
3
Remove the photoconductor from its package
and pull off the protective sheet.
Caution: Do not touch the belt on the top
of the photoconductor or the blue roller beneath
it; otherwise, print quality may decrease.
Avoid exposing the photoconductor to light any longer than necessary.
Do not touch any other components inside the CX11N.
4
Hold the photoconductor by
its handle and insert it into the
slots marked with blue arrows
inside the CX11N. Push it in
until it clicks into place.
5
Flip down the orange lever,
then close cover B.
6
Pull out the extension tray if necessary. Lower the scanner unit to its
original position.
4
Set Fax/Printer Information
CX11NF
1
Select the Country: Press the
then press the
2
Select the Language: Press the
then press the
3
Set the Date and Time: Press the
month, day, hour, and minute. Press the
item. The CX11NF then resets itself and reboots.
4
Turn off the CX11NF.
5
Connect an RJ-11 cord to
the telephone line interface
on the CX11NF and to the
RJ-11 jack on the wall.
Note: An RJ-11 cord is not
included with the CX11NF.
6
Turn on the CX11NF.
CX11N
1
Press the
The Setup light turns on and the LCD screen shows Setup Mode for a
few seconds, then changes to the Setup menu screen.
2
Press the ▼ button until Printer Settings is selected, then press the
button.
3
Press the ▼ button until Setup Menu is selected, then press the
button.
button.
button.
Setup button.
or
button to select the country,
or
button to select the language,
or
button to select the year,
button after selecting each
Print Page