Epson Apex80 Product Support Bulletin - Page 18

Browse online or download pdf Product Support Bulletin for Printer Epson Apex80. Epson Apex80 20 pages. Product support bulletin(s)
Also for Epson Apex80: Product Support Bulletin (3 pages), Product Support Bulletin (8 pages), Product Support Bulletin (2 pages)

Print Page
Epson Apex80 Product Support Bulletin
Q7.
How do I set the EPL- 6000 back to the factory - default settings using the
SelecType buttons on the printer's front panel?
A.
Set the printer to OFF- LINE, then press the SelecType button. The next
step is to press and hold the "RESET/CONTINUE" button for approximately
3 seconds, when "INlTlALlZE" appears on the LCD display release the button.
The final step is to press and hold the "RESET/CONTINUE" button again for
approximately 3 seconds, when "RESET" will appear on the display release the
button. The printer has now been reset to the factory- default settings.
NOTE: lf the INTERFACE, DATA BUFFER, 'or OVERLOAD BUFFER settings
are changed the printer must also be powered "OFF" then back "ON" in order
for these changes to become active.
Q8.
Why does the EPL- 6000 display "DATA IN BUFFER" on the LCD and not
print anything when I send data to it?
A.
The EPL- 6000 is a page printer meaning that it prints a whole page at a
time. If the EPL- 6000 doesn't receive a full page of data or a FORM FEED
command from the software it will not print
Q9.
H
do I eject the page from the EPL- 6000 when "DATA IN BUFFER" is
OW
shown on the LCD display?
A.
Press the "RESET/CONTINUE" button to eject the page.
Q10.
Where can I purchase a Technical Reference Manual (programmer's manual)
for the EPL-6000?
A.
A Technical Reference Manual for the HP LaserJet Series II printer can be
purchased directly from HP's Direct Marketing Department. The phone number
for HP's Direct Marketing Department is 800-538-8787. The part number
for HP's LaserJet Series II Technical Reference Manual is: 33440- 90905.
Q11.
Why does the EPL- 6000 beep and display "ERROR 20" several times when
I attempt to use downloaded (soft) fonts?
A.
An "ERROR 20" message indicates you have exceeded the printer's available
user memory. A solution to this would be to add more user memory to the
EPL- 6000. The P/N for the optional 2MB memory board is IBS401.
PSB No: P-0058A
Page: 3 of 5