3Com NBX V3000 Analog Release Note

Browse online or download pdf Release Note for Switch 3Com NBX V3000 Analog. 3Com NBX V3000 Analog 8 pages. Ip telephony solution
Also for 3Com NBX V3000 Analog: Release Note (11 pages), Upgrade Information (2 pages), Quick Reference Manual (2 pages), Release Note (4 pages), Datasheet (4 pages), Instruction Sheet (2 pages)

Print Page
3Com NBX V3000 Analog Release Note
September 2, 2005
NBX V3000
®
SuperStack3
NBX V5000
NBX 100
Applications in Release R5.0 .......................................................................................................................2
Problems Corrected in This Release............................................................................................................2
Known Anomalies and Considerations in Release R5.0.6...........................................................................4
CAUTION: 3C10165D E1 Digital Line Cards and 3C10116D T1 Digital Line Card can have their flash
memory corrupted if you remove power from the cards or remove the cards from the NBX chassis while
they are receiving their download after a system upgrade. (TT ID 5306)
License Note: NBX R5.0 is a major release of system software and requires a chargeable license key to
enable it. This license key is pre-installed on new systems at no charge. If you are upgrading the software
of an existing system, you must purchase and enter an NBX 5.0 license key into the NBX NetSet™ utility to
fully enable the R5.0 software. The system allows you to install the R5.0 license key prior to or after you
install the R5.0 software on the system. If you are running any previous release of NBX system software,
you need only purchase the R5.0 license to upgrade. If you already have an R5.0 license, you do not need
a new license key to install and run R5.0.6. For complete upgrade instructions, see the NBX System
Software Upgrade Instructions available on the NBX Resource pack CD or from the Support and
Downloads area of www.3com.com (upgr_nbx50.pdf).
NBX Call Reports Note: The Call Data Record format has changed at NBX R5.0. If you are using NBX
Call Reports R4.3 or lower, and you want to continue to use NBX Call Reports to view calling data, you
must uninstall NBX Call Reports, purge existing call data, and then install NBX Call Reports R5.0. For
detailed instructions, see the NBX System Software Upgrade Instructions.
Copyright © 2005, 3Com Corporation. All Rights Reserved.
Unless otherwise indicated, 3Com registered trademarks are registered in the United States and may be registered in other countries.
3Com, the 3Com logo, NBX, and SuperStack are registered trademarks and NBX NetSet and pcXset are trademarks of 3Com
Corporation. Other brand and product names may be registered trademarks or trademarks of their respective holders.
Release Notes for NBX
(Maintenance Release)
®
Release R5.0.6
Rev NBX-All – September 2005