ARCHIPELAGO LIGHTING LED SL-4 Installation Instructions
Browse online or download pdf Installation Instructions for Outdoor Light ARCHIPELAGO LIGHTING LED SL-4. ARCHIPELAGO LIGHTING LED SL-4 4 pages. Led shop/utility light
PREPARATION
Before beginning installation of the product, make sure
all parts are present. If any part is missing or damaged,
do not attempt to assemble, install or operate the
product.
Estimated Assembly Time: 10 Minutes
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install the product
1.
WARNING: RISK OF SHOCK
!
House electrical current can cause painful shock or serious injury unless handled properly. For your safety, always
remember to:
-Turn off the power at the fuse or circuit breaker box before you install the shop light.
2. This shop light is designed for use in a circuit protected by a fuse or circuit breaker. This shop light is intended to be
installed
directly beneath a ceiling-mounted receptacle and any excess cord should be kept out of the workspace. It is
also designed to
installed in accordance with local electrical codes. If you are unsure about your wiring, consult a
qualified electrician or local
3. Account for small parts and destroy packing material, as these may be hazardous to children.
4.
WARNING: RISK OF INJURY
!
Do not open shop light. No serviceable parts inside.
5.
WARNING: RISK OF FIRE
!
Most dwellings built before 1985 have a supply wire rated 60˚C. Do not overload the circuit and wiring. Consult a
qualified
electrician.
6.
This device complies with part 15 of the FCC Rules.
!
(1) This device may not cause harmful interference, and
interference that may cause undesired operation. Note: This
limits for a Class B digital device, pursuant to part 15 of the FCC
protection against harmful interference in a residential installation
frequency energy and, if not installed and used in accordance with the
radio communications. However, there is no guarantee that interference
equipment does cause harmful interference to radio or television reception,
equipment of and on, the user is encouraged to try to correct the interference by one
Reorient or relocate the receiving antenna. Increase the separation between the equipment
equipment into an outlet on a circuit different from that to which the receiver is connected. Consult
experienced radio/TV technician for help.
LIMITED WARRANTY
For 5 years from the date of purchase, this product is warranted for the original purchaser to be free from defects in
materials and workmanship through normal use. In order to obtain this service, please return this item to the place of
purchase with valid proof of purchase and the defective product will be replaced at no charge. This guarantee gives
you specific legal rights, and you may have other rights that vary from state to state.
This shop light was carefully packed and thoroughly inspected before leaving our factory.
ARCHIPELAGO LIGHTING | MONTCLAIR, CA (866) 912-3220 FAX (909) 627-2887 www.archipelagolighting.com
5012662
electrical inspector, and consult your electrical code.
|
M
INSTALLATION INSTRUCTIONS
PACKAGE CONTENTS
PART
DESCRIPTION
A
Fixture
Assembly
B
Install screw
C
Chains
D
"J" Hooks
E
Wall anchors
E
Operation is subject to the following 2 conditions:
(2) this device must accept any interference received, including
equipment has been tested and found to comply with the
Rules. These limits are designed to provide reasonable
This equipment generates, uses and can radiate radio
instructions, may cause harmful interference to
will not occur in a particular installation. If this
which can be determined by turning the
|
1
LED SHOP/UTILITY LIGHT
O
D
E
L
L
E
D SL-9/4/7.5/40/4RM
QUANTITY
1
3
2
2
3
D
B
C
A
or more of the following measures:
and receiver. Connect the
the dealer or an
|