CREE LIGHTING ZR22MT-SC1 Installation Instructions - Page 2

Browse online or download pdf Installation Instructions for Light Fixture CREE LIGHTING ZR22MT-SC1. CREE LIGHTING ZR22MT-SC1 5 pages. Commercial specification troffers with emergency driver & smartcast technology

Print Page

TO INSTALL:

Luminaire Hooks

Cable Slots

Junction Box Cover

2 of 5

T-bar

Power Supply

1st:

90° Bend

T- BAR CEILING MOUNTING

STEP 1:

Bring the ZR-MT troffer up into the

T-Bar grid.

STEP 2:

Locate the luminaire hooks and

bend them out 90 degrees for

installation. See Figure 1.

NOTE: The luminaire hooks ship

bent in and need to be bent out for

installation.

STEP 3:

2nd: Bend

Against T-bar

Then bend the luminaire hooks

against the T-Bar to secure the

luminaire. See Figure 1.

SUSPENDED MOUNTING

STEP 1:

Disconnect power to circuit by

T-bar

turning circuit breaker OFF before

installation.

STEP 2:

Attach customer supplied cables

to the (2) cable slots on each side

of the housing. See Figure 2 and 3.

STEP 3:

Attach customer supplied cables

to mounting surface using

customer supplied hardware.

Ensuring that mounting surface

can support the luminaire.

STEP 4:

Make wiring connections per the

Electrical Connection section.

STEP 5:

Switch the circuit BREAKER on.

STEP 6:

Make sure the WIM blue LED has

a double blink pattern. If not,

please proceed to Troubleshooting

section. Otherwise, you can

proceed to commission the zone

controller. Please refer to the

Smartcast® document ion for

details. See Figure 4 on the next

page.

LPN00696X0001A0_A