ayerbe AY - 1600 Instruction Manual - Page 14

Browse online or download pdf Instruction Manual for Vacuum Cleaner ayerbe AY - 1600. ayerbe AY - 1600 19 pages. Wet and dry vacuum cleaner

Print Page

ON/OFF Switch

Clasp.(x2)

Vacuum hose connector.

10.

Container.

11.

Drain extension hose

12.

Drain outlet.

13.

Foot with large wheel.(x2)

14.

Foot with castor.(x2)

15.

Stainless steel tubes

16.

Orange Cloth pre filter bag

17.

Cartridge filter set

18.

Combo Brush

19.

Round brush

20.

Hose

21.

50-60L qualified dust bag

22.

Crevice tool

23.

Foam filter

24.

Combo nozzle

3. ASSEMBLY

3.1. Ensure the mains plug is

disconnected.(fig.1)

3.2. Undo clasps.(fig.2)

3.3. Lift off the top section

assembly.(fig.3)

3.4. Remove contents from inside the

container. Make sure you have all

contents as listed.

3.5.

With the power head removed,

turn the container upside down.

Insert the two casters into the

socket on to bottom of the castor

feet and apply pressure until

castors snap into place.(fig.4)

3.6.

Insert the rear wheel shaft (S) into

the rear support block. Insert

washer (Q) on the shaft, then

insert rear wheel (N) on the shaft.

Insert the 'R' lock pin into the hole

on the end of the shaft to lock the

wheel. Snap the hub cap (O) on to

the wheel. Repeat the same steps

at the other end of the shaft. (fig. 5)

3.7

Insert the push handle into the

handle sockets mounted on the

sides of the tank. Push down until

the lock pin clicks in place. (fig. 6)

3.8a. For dry vacuum cleaning fit the

supplied cartridge filter.(fig.7)

3.8b. Or for dry vacuum cleaning fit the

optional dust bag.(fig.8)

3.8c.

For wet vacuum cleaning fit the

supplied foam filter.(fig.9)

3.9.

Replace the top section onto the

container.(fig.10)

3.10. Align the top section with the

clasps and snap into place, by

applying pressure at the mid point

of the clasps.(fig.11)

3.11. Insert the large end of the hose

into the front inlet of the container

and screw on it till tight.(fig.12)

3.12. Choose the desired nozzle/

Stainless steel tube(s) and push it

onto the suction tube.(fig.13)

- 14 -