Creek Company ODC 616 OUTDOOR DISCOVERY CRAFT Assembly Instructions - Page 2
Browse online or download pdf Assembly Instructions for Boat Creek Company ODC 616 OUTDOOR DISCOVERY CRAFT. Creek Company ODC 616 OUTDOOR DISCOVERY CRAFT 4 pages.
I.
SEAT ASSEMBLY
1. Assemble Seat Back to Seat Bottom using Seat Assembly Pins (see figure 1a).
II. ASSEMBLE FRAME
NOTE: Your Frame Assembles using (8) Short Snap Pins. Please follow instructions accordingly.
1. Assemble Seat to Seat Support Frame Member using (4) Seat Screws. (See Figure 1a)
2. Assemble Seat Support Frame Member to Left and Right Frame Members using (4) of the Short Snap Pins while at the same time
inserting Rear Frame Bar in to Left and Right Frame Members using (2) Short Snap Pins (see figure 1).
3. Assemble U-Bar to Left and Right Frame Members using (2) Short Snap Pins (see figures 1).
III. PONTOON INFLATION
NOTE: See figure 3b for a detail of the valve assembly. Before inflation, be sure to fully seat each valve assembly into the
Pontoon, screwing tightly by hand. When fully seating Valve Assembly, be sure that the Valve Plate is in place around Valve
Assembly and not restricting the Valve Assembly from a full seal. After inflating, be sure to fully seat the top cap on to each
Valve Assembly, screwing tightly by hand. Both are required for an airtight seal.
1. Inflate each Pontoon. The Valve is located inside the Storage Pocket of each Pontoon.
Inflate until firm (do not over inflate). Pump is available from the Creek Company or most sporting good stores.
2. Again, be sure top Valve Cap and Valve Assembly are fully seated.
PONTOON DEFLATION: Unscrew entire Valve Assembly from Pontoon.
IV. ATTACH PONTOONS TO FRAME
NOTE: Always inflate the Pontoons first, before attaching to Frame.
1. Position inflated Pontoons under the Left and Right Frame Members with ODC 616
logos oriented to the outside. The Frame Members fit around the Storage Pockets.
2. Attach Pontoons to Frame as illustrated in figures 3 and 3a. NOTE: Be sure the straps are pulled tight through the
Cam-lock Buckles. Frame should be positioned forward or aft on the Pontoons to achieve center of gravity for an even
ride when fully loaded on the water.
ODC 616
O O U U T T D D O O O O R R D D I I S S C C O O V V E E R R Y Y C C R R A A F F T T
ASSEMBLY INSTRUCTIONS
(PUMP NOT INCLUDED)
T T M M
T T M M
™
.