Creek Company ODC CLASSIC XL Assembly Instructions - Page 4

Browse online or download pdf Assembly Instructions for Sports & Outdoors Creek Company ODC CLASSIC XL. Creek Company ODC CLASSIC XL 4 pages. Outdoor discovery craft

Print Page

Your ODC Outdoor Discovery Craft

IF YOU EVER HAVE ANY QUESTIONS OR PROBLEMS WITH YOUR ODC CLASSIC XL

TURN IT TO THE DEALER YOU BOUGHT IT FROM. PLEASE CONTACT THE CREEK COMPANY

DIRECTLY TOLL FREE AT 1-800-843-8454. WE ARE OPEN M-F 9AM-5PM MOUNTAIN TIME. OR CONTACT US VIA

HIN is located on square tubing of seat support frame member and on right main frame member (See Figure 1)

Please read and follow carefully.

1. Always wear a US Coast Guard approved personal flotation device when in your ODC CLASSIC XL

2. Never float alone.

3. Always check your ODC CLASSIC XL

4. Never use your craft if you suspect the Air Bladders, outer skin or stitching has been damaged.

5. Never overinflate your ODC CLASSIC XL

6. Never use your ODC CLASSIC XL

7. Your ODC CLASSIC XL

1. If your Pontoon Bladder is losing air, please check that Valve Assembly and Top Valve Cap are fully seated. Reseat valve

assembly and repeat pontoon inflation instructions.

2. Do not store your ODC CLASSIC

3. If you are leaving your ODC CLASSIC XL

pressure inside the Pontoons to a dangerous level. Let some of the air out of the pontoons if the craft will be out of the water in the

sun for any length of time, or if it is stored in a vehicle, etc.

4. A gain in altitude will increase the pressure in the Pontoons also. If you are taking your inflated ODC CLASSIC XL

low elevation to a high elevation, be sure to let some of the air out of it.

5. For short term storage, we recommend you let some air out of your pontoons.

6. For long term storage, we recommend you make sure your ODC CLASSIC XL

of the sunlight in a cool dry area.. Do not store your wet ODC CLASSIC XL

Frame and other component damage.

7. Repairing Bladder, use enclosed patch kit. Identify puncture. Fully deflate Bladder. Clean and dry area around puncture. Apply

glue to puncture area and patch using applicator straw. Press patch over puncture area. Allow 24 hours to dry, before inflating.

8. Note: Metal parts may rust and are not covered under warranty.

Ask for them where you bought your ODC SUPERSPORT XR 1™, or visit the Creek Company Store at www.CreekCompany.com

ODC CLASSIC XL

OUTDOOR DISCOVERY CRAFT

Please follow inflation instructions and warnings carefully.

E-MAIL AT [email protected].

Air Bladders, outer skin and stitching for possible damage before you use your craft.

without the Pontoons fully inflated.

is not designed for use in salt water.

CARE AND MAINTENANCE:

in direct sunlight.

out in the sun for any amount of time, be aware that the heat can increase the

Accessories are available for your ODC CLASSIC XL

The Creek Company Ltd. , PO Box 773892, Steamboat Springs, CO 80477

Specifications and other details subject to change without notice. All Creek Company

products are guaranteed against defects in material and workmanship for the

This does not cover damage due to misuse or normal wear and tear.

is designed to give you many years of service.

Warning:

is completely dry, deflated and stored out

in freezing temperatures as this may result in

email: [email protected] • Made in China

life of theproduct to the original owner.

PLEASE DO NOT RE-

from a