Cres Cor H-339-1813C-GMR Operating And Maintenance Instructions

Browse online or download pdf Operating And Maintenance Instructions for Commercial Food Equipment Cres Cor H-339-1813C-GMR. Cres Cor H-339-1813C-GMR 4 pages. Holding cabinet

Print Page

5925 Heisley Road • Mentor, OH 44060-1833

OPERATING and MAINTENANCE INSTRUCTIONS

ELECTRICAL SPECIFICATIONS:

MODEL

H-339-1813C-GMR

H-339-1813C-GML

HOW TO INSTALL UNIT:

Plug cord into 15-Amp wall outlet.

Place cabinet in a well ventilated area.

Hang wire racks inside the cabinet.

Push the switch on, turn the thermostat to No. 10

and run the unit for one hour.

NOTE: DO NOT PUT IN FOOD! This step is to

burn off manufacturing oils and excessive

adhesive.

6. Let the cabinet cool and wipe inside clean with

detergent and hot water before use.

Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com

FOR HOLDING CABINET

Volts

Watts

120

900

FIGURE 1

Amps

Hertz

7.5

HOW TO OPERATE UNIT: (Figure 1)

Push switch "ON". Yellow light will come on.

Turn thermostat to the temperature you need.

NOTE: No. 7½ setting will give you about 180° F

(82°C). Proper food holding temperature is

140° F (60°C) or higher.

3. Preheat cabinet for 45 minutes

4. Put food into cabinet.

5. Turn the wing nut on the door vent to open the vent

when less humidity is needed.

To Turn Off Unit:

Push switch "OFF". The yellow light will go off.

NOTE: Optional digital thermometer will ﬂ ash if cabinet

temperature is below 140°F or above 250°F.

Call the factory if you need different settings.

Insulated

FL-0520-3

Holding Cabinet

Rev. 7 (4/06)

Page 1 of 4

Phase

NEMA

5-15