Cres Cor CO151XWUA5DE2081 Installation, Operation And Maintenance Manual - Page 4

Browse online or download pdf Installation, Operation And Maintenance Manual for Convection Oven Cres Cor CO151XWUA5DE2081. Cres Cor CO151XWUA5DE2081 15 pages. Humidity convection ovens

Print Page

Convection

Humidity Oven

Page 4 of 14

Rev. 4 (6/15)

HOW TO USE ROAST-N-HOLD CONTROL:

*Push the lighted switch on the control panel; the oven

will start heating and stay in HOLD mode .

*The display will read "LOTPR" (low temperature)

below 140°F . (60°C .) .

NOTES: Preheat for one (1) hour after start up before

loading the food for best results when

retherming or cooking heavy loads .

If a power outage occurs or the cabinet is shut

off during a cook cycle, when it is turned on

again all lights on the control will flash to

indicate a disruption . Control will resume

the last cook cycle used . Press any button

to stop the blinking .

If your model does not have a food probe, continue to

section "-DE OVENS" below.

If your model has a food probe,

skip to section "-DX OVENS" on page 5.

-DE OVENS:

Cooking:

1 . Press the COOK button .

2 . Turn the control knob to the desired cooking

temperature between 180°F (82°C) and 350°F (176°C) .

3 . Push the knob to set the temperature .

4 . The control automatically switches to allow you to set

HOLD temp . (Continue to step 1 below) .

Holding:

(To use as holding cabinet only, skip steps 1-4 above and

Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com

FL-2373

OPERATING INSTRUCTIONS

5925 Heisley Road • Mentor, OH 44060-1833

press HOLD button . Complete steps 1-3 below .)

1 . Turn the control knob to the desired holding

temperature between 80°F (26°C) and 220°F (104°C) .

2 . Push the knob to set the temperature .

3 . The control automatically switches to allow you to set

cook time .

Setting the Timer:

1 . Turn the control knob to the desired hours/minutes .

2 . Push the knob to set the time .

3 . The control automatically switches to PREHEAT

mode and will display "PrEHt"

Running the Cycle:

1 . The control will flash "PUSH StArt" after the cabinet

has preheated to the set temp and the alarm will sound .

NOTE: A short beep will occur every 90 seconds as

a reminder . This can be turned off in the user menu by

holding the knob and the TIME buttons together for

5 seconds, then scrolling to "PSrE", changing "y" to

"n", scrolling to "End", and pushing the knob to set .

2 . Load foods into oven and close the door .

3 . Push the START button to begin the Cooking process .

Display will change between the setpoint temperature

and the countdown of the timer .

4 . The alarm will sound after the time is done and the

oven will switch back into HOLD mode . The timer

will now count up, showing how long the food has

been holding .