Digilock NEXT Sola3 Keypad Product Manual - Page 2
Browse online or download pdf Product Manual for Locks Digilock NEXT Sola3 Keypad. Digilock NEXT Sola3 Keypad 5 pages. Key managed
Also for Digilock NEXT Sola3 Keypad: Product Manual (9 pages)
Print Page
Programming Instructions
Default Settings
Functionality = Shared Use
Initial Setup
New locks operate with the default Owner and Manager Codes. A new Owner and Manager Code must be programmed on the lock to
prevent the default codes from operating the lock.
Program a New Owner Code
The Owner Code can only be programmed using the current Owner Code.
a.
Press = ` [current Owner Code] ` . A two-tone beep will be heard and the LED will turn on.
b.
Press = [new Owner Code] ` . A two-tone beep will be heard.
c.
To confi rm, press = [the same new Owner Code] ` . Two sets of two-tone beeps will be heard and the LED will turn off.
Program a New Manager Code
To Program the Manager Code using the Owner Code:
a.
Press = ` [Owner Code] ` . A two-tone beep will be heard and the LED will turn on.
b.
Press = [new Manager Code] ` . A two-tone beep will be heard.
c.
To confi rm, press = [the same new Manager Code] ` . Two sets of two-tone beeps will be heard and the LED will turn off.
To Program the Manager Code using the current Manager Code:
a.
Press = ` [current Manager Code] ` . A two-tone beep will be heard and the LED will turn on.
b.
Press = [new Manager Code] `. A two-tone beep will be heard.
c.
To confi rm, press = [the same new Manager Code] ` . Two sets of two-tone beeps will be heard and the LED will turn off.
Set Lock Functionality
Each lock can be set for either shared or assigned use functionality. In shared use functionality, the user enters a self-selected 4-digit
code to lock and later unlock. Once unlocked, the lock is available to be used by a different user. In assigned use functionality, the lock
is programmed with an assigned 4-digit User Code. The user enters the assigned 4-digit User Code and turns the handle to unlock and
turns the handle again to relock.
Press = to check functionality. If in shared use, LED is RED. If in assigned use, LED is GREEN.
Set lock for shared use functionality:
a.
Press = ` [Owner Code] ` . A two-tone beep will be heard and the LED will turn on.
b.
Press = 56 ` . Two sets of two-tone beeps will be heard and a
c.
Make sure the lock is unlocked and available for use. Use the Owner or Manager Code to unlock.
Set lock for assigned use functionality:
a.
Press = ` [Owner Code] ` . A two-tone beep will be heard and the LED will turn on.
b.
Press = 65 ` . Two sets of two-tone beeps will be heard and a
c.
Assign a User Code to the lock. Follow Assign a New User Code instructions.
d.
Make sure the lock is in the locked position. Use the Owner or Manager Code to lock.
2
Product Guide
INSTALL THE LOCK OR DETERMINE CONFIGURATION PRIOR TO
PROGRAMMING AND OPERATING.
= 1 2 3 4 5 6
Owner Code
(6-digit code)
Keypad
Code Managed
Shared & Assigned Use Functionality
Manager Code
RED
LED will fl ash twice.
GREEN
LED will fl ash twice.
= 1 2 3 4 5
(5-digit code)