Cresco 10SW Manual - Page 4
Browse online or download pdf Manual for Spreader Cresco 10SW. Cresco 10SW 15 pages. Fertilizer and salt spreader
Also for Cresco 10SW: Manual (6 pages)
Assembling your Cresco 10
ASSEMBLING THE SLIDER SYSTEM, LINKAGE & LOWER FRAME:
You will need a phillips head
screwdriver, one pair of plyers/
grips and an m6 metric spanner.
3
Locate & tighten the 4 screws &
washers to fix the required slider
(winter or summer) into position.
Make sure the screws are not
overly tight and the slider can
slide backward and forward.
6
Secure the lower linkage (21) in
place using the R pin small as
shown.
1
Winter Slider
If you are using the spreader
for winter, slide the winter
application into position as
shown above.
4
Locate the lower linkage (21)
and place it through the pivot
bracket (20).
7
Take the two lower frames (14)
and attach them to the hopper
body (16) using the M6x60 bolts
(9). SEE NOTE.
3
2
Summer Slider
If you are using the spreader
for fertiliser or seed, slide
the summer application into
position as shown above.
5
Push the free end of the lower
linkage (21) through the centre
hole of the chosen slider.
NOTE
When placing the legs on the
hopper, make sure the two
holes on the side of the lower
frame (Item 14) are on the
outside. There should be one
hole on the inside.