Accusound ES 120 Instruction Manual - Page 4

Browse online or download pdf Instruction Manual for Home Theater System Accusound ES 120. Accusound ES 120 4 pages. Eclipse series home theatre system

Print Page

Speaker Terminals

Speaker wire can be inserted into the hole in the shaft of the speaker's and transmitter terminals.

Simply strip away approximately 10mm of the wire jacket, push the connection terminal in and insert the

wire through the hole in the shaft. Release the terminal and it holds the speaker wire in place. Make

sure no stray wire strands touch the opposite terminal. If a wire is loose, it can cause a crackling or

static type sound that can be heard through the speaker. If it comes loose and touches the other

terminal, it can cause your receiver to go into protection mode.

Front Speaker Connections

On the back of the 2 front speakers are 2 push in connection terminals. Red is positive (+) and Black is

negative (-). From your receiver's positive terminal connect the speaker wire to the (+) mark which is the

Red terminal on the speaker. Push the terminal in and insert the wire into the hole. Release the terminal

Wireless Transmitter Rear Panel

and the wire is connected. Connect the negative (-) wire to the Black terminal.

Centre Speaker / Wireless Transmitter

On the back of the transmitter there are 3 sets of speaker connections. Look at the wiring diagram on

page 3 for the connections. Connect speaker wire from your receiver's surround speaker terminals and

the centre speaker terminals to the left and right inputs and centre input on the transmitter. Please

ensure that the left surround output goes to the left surround input and the same for the right side. Do

the same with the centre speaker connection. . Make sure the polarity + to + and - to - is correct.

Power Switch

There is a 2 pin power socket on the back of the centre/transmitter. Plug the power cable supplied in.

There is a power switch. Turn this on and leave it on as this goes to standby when the system is not

being used.

Wireless Surround Speaker Connection

Plug the surround speakers into the power. Turn on the rear power switch and set the volume control at

zero. This can be adjusted to fine tune later. When you are not using the system for a long period or go

on holidays, turn the power switch to off on the back of each surround speaker.

Subwoofer Connection

Wireless Transmitter Surround set up

To get connected turn your receiver on and have a movie or music playing. If you have a setting called

All Channel on your receiver, use this for the set up as it will give you sound in all the speakers. If you

play a 5.1 movie you may not get sound out of the wireless surround speakers unless the movie is

producing sound from the surround speakers.

Wireless Transmitter built into Centre Speaker

The wireless transmitter works on 2.4000GH to 2.4835GH. The transmitter finds a clear channel if you

have interference with cordless hand phones, wireless internet or microwave ovens.

Wireless Receiver

Speaker Terminal Connection