Cisco 3750 - Catalyst EMI Switch Installation Manuallines - Page 10

Browse online or download pdf Installation Manuallines for Switch Cisco 3750 - Catalyst EMI Switch. Cisco 3750 - Catalyst EMI Switch 47 pages. Catalyst 3750 series switches
Also for Cisco 3750 - Catalyst EMI Switch: Datasheet (18 pages), Faq (10 pages), Product Bulletin (5 pages), Product Support Bulletin (6 pages), Product Overview (25 pages), Description (1 pages), Datasheet (23 pages), Product Support Bulletin (6 pages), Getting Started Manual (27 pages), Datasheet (23 pages), Getting Started Manual (33 pages)

Print Page

Preparing for Installation

Powering On the Switch and Running POST

Note

Step 1

Step 2

Step 3

Warning

Catalyst 3750 Switch Hardware Installation Guide

3-10

If your configuration has an RPS, connect the switch and the RPS to the same AC

power source. See the

Cisco RPS documentation for more information.

Always put the RPS in standby mode when you are connecting devices to it and

in active mode during normal operation.

To power on the switch, follow these steps:

Make sure that you have started the terminal emulation software program (such as

ProComm, HyperTerminal, tip, or minicom) from your management station. See the

"Connecting a PC or Terminal to the Console Port" section on page 3-8

information on connecting to the switch console port.

Connect one end of the AC power cord to the AC power connector on the switch.

Connect the other end of the power cord to an AC power outlet.

If you are installing the Catalyst 3750-24TS, 3750G-24T, or 3750-48TS switches,

you can use the Cisco RPS 300.

Attach only the Cisco RPS 300 (model PWR300-AC-RPS-N1) to the RPS

receptacle

If you are installing the Catalyst 3750-24TS, 3750G-24T, 3750G-24T, or the

3750-48TS switches, you can use the Cisco RPS 675.

Attach only the Cisco RPS 675 (model PWR675-AC-RPS-N1=) to the RPS

receptacle

As the switch powers on, it begins POST, a series of tests that run automatically

to ensure that the switch functions properly. When the switch begins POST, the

System, the RPS, the Master, the Status, the Duplex, the Speed, and the Stack

"Power Connectors" section on page

Chapter 3

Switch Installation

2-15, and refer to the

for

78-15136-01