Cisco 3750 - Catalyst EMI Switch Installation Manuallines - Page 42

Browse online or download pdf Installation Manuallines for Switch Cisco 3750 - Catalyst EMI Switch. Cisco 3750 - Catalyst EMI Switch 47 pages. Catalyst 3750 series switches
Also for Cisco 3750 - Catalyst EMI Switch: Datasheet (18 pages), Faq (10 pages), Product Bulletin (5 pages), Product Support Bulletin (6 pages), Product Overview (25 pages), Description (1 pages), Datasheet (23 pages), Product Support Bulletin (6 pages), Getting Started Manual (27 pages), Datasheet (23 pages), Getting Started Manual (33 pages)

Print Page

Connecting to the 10/100 and 10/100/1000 Ports

Step 5

Step 6

Connecting to the 10/100 and 10/100/1000 Ports

Caution

Step 1

Catalyst 3750 Switch Hardware Installation Guide

3-42

Grasp the SFP module between your thumb and index finger, and carefully

remove it from the module slot.

Place the removed SFP module in an antistatic bag or other protective

environment.

The switch 10/100 and 10/100/1000 ports configure themselves to operate at the

speed of attached devices. If the attached ports do not support autonegotiation,

you can explicitly set the speed and duplex parameters. Connecting devices that

do not autonegotiate or that have their speed and duplex parameters manually set

can reduce performance or result in no linkage.

To maximize performance, choose one of these methods for configuring the

Ethernet ports:

Let the ports autonegotiate both speed and duplex.

•

Set the port speed and duplex parameters on both ends of the connection.

Follow these steps to connect to 10BASE-T, 100BASE-TX or 1000BASE-T

devices:

To prevent electrostatic-discharge (ESD) damage, follow your normal board and

component handling procedures.

When connecting to workstations, servers, routers, and Cisco IP Phones, connect

a straight-through cable to an RJ-45 connector on the front panel. (See

Figure

3-38.) When connecting to switches or repeaters, use a crossover cable.

(See the

"Cable and Adapter Specifications" section on page B-5

descriptions.)

When connecting to 1000BASE-T-compatible devices, be sure to use a

Note

twisted four-pair, Category 5 cable.

Chapter 3

Switch Installation

for cable-pinout

78-15136-01