Accusplit AX602M500 Operating Instructions Manual - Page 11

Browse online or download pdf Operating Instructions Manual for Watch Accusplit AX602M500. Accusplit AX602M500 15 pages. Digital quartz stopwatches

Print Page

Accusplit AX602M500 Operating Instructions Manual

1. How to Delete All Memory Segments

40-41

How to set the timer

Press and hold [RECALL] (S1) for 2 seconds to

activate timer setting. Timer setting starts with

second digits, which are shown blinking. You can

press [START • SPLIT] (S3) to advance the ﬂ ashing

digits. Or you can press [STOP • RESET] (S2) to

select other digits. The setting follows the

sequence: second, minute, hour and timer

operating mode (CR, CS and CU).

NOTE: You can only set Hour, Minute and Seconds.

The 1/10 second cannot be set.

Press and hold [RECALL]

for 2 seconds. Timer

setting starts with

second digits.

42-43

Pacer Mode

Press [MODE] until you enter the Pacer mode.

In the Pacer mode, you can set the standard

pacer speed from 5 to 240 beats per minute in

the following values:

5, 10, 20, 30, 40, 50, 60, 80, 100, 120, 150, 180,

200, 240

In Pacer mode, the display will be:

PACER

P -

The digits are ﬂ ashing to indicate that the pace

count is ready for setting. Press [STOP • RESET] to

select the pace count. Once the desired pace count

is selected, press [START • SPLIT] to conﬁ rm the

° 5 beats per minute

Press [STOP • RESET] (S2)

to move to minute digits.

Press [STOP • RESET] (S2)

further to go to hour digits.

Hour digits can be adjusted

from 0 to 19.

Press [STOP • RESET] (S2)

again to adjust the operating

mode. Press [START] to switch

the operating modes among

CR, CS and CU.

At the end of setting, press

[RECALL] (S4) or [MODE] to

leave setting mode.

setting and start the pace count. The display will

show the elapsed time on the upper line, the pace

count number on the middle and the pace count

value on the lower display.

Press [STOP • RESET] to stop the pace count; the

display will freeze. To restart the

pace count, press [START • SPLIT]

again. Or press [STOP • RESET]

to reset the time elapsed and the

pace count number .

° Elapsed time

° Pace count number

° PACE count