Cisco 4900M - Catalyst Switch Troubleshooting Manual

Browse online or download pdf Troubleshooting Manual for Switch Cisco 4900M - Catalyst Switch. Cisco 4900M - Catalyst Switch 6 pages. 10/100base-t
Also for Cisco 4900M - Catalyst Switch: Installation Manual (8 pages)

Cisco 4900M - Catalyst Switch Troubleshooting Manual

Troubleshooting the Installation

This chapter describes how to troubleshoot the Catalyst 4900M switch hardware installation and
contains these sections:
If your system has problems starting up, use the information in this chapter to help isolate the cause.
Problems with the initial startup are often caused by poor or improper connections. Although
temperature conditions above the maximum acceptable level rarely occur at initial startup,
environmental monitoring functions are included because they also monitor DC-line voltages.
For configuration questions or problems, refer to the software configuration guide or the command
Note
reference publication to configure or enable the interfaces.

Getting Started

When the initial system boot is complete, verify the following:
If all of these conditions are met and the hardware installation is complete, refer to the software
configuration guide and the command reference publications to troubleshoot the software. However, if
any of these conditions are not met, use the procedures in this chapter to isolate and, if possible, resolve
the problem.
78-18350-02
Getting Started, page 1-1
Problem Solving to the System Component Level, page 1-2
Identifying Startup Problems, page 1-2
Troubleshooting the Power Supply, page 1-4
Contacting Customer Service, page 1-4
Power supplies are supplying power to the system.
The system fan assembly is operating.
System software boots successfully.
1
C H A P T E R
Cisco Catalyst 4900M Switch Installation Guide
1-1