Accustic Arts POWER I you Manual - Page 11

Browse online or download pdf Manual for Amplifier Accustic Arts POWER I you. Accustic Arts POWER I you 13 pages.

Print Page

the menu.

9. Factory setting (reset of all settings)

In this menu, the factory settings can be reset, i. all individually set values will be lost if you reset them

here.

To reset, press and hold the right knob until the countdown timer counts down from 5 to 0. When the

zero is reached, the amplifier switches off and all settings are reset to the factory settings (factory

setting). If the rotary knob is released before reaching zero, the reset is aborted.

By turning the left knob to the left you get to the menu in front of it. Press the left knob to exit the

settings menu.

8. Looking after your equipment

The ACCUSTIC ARTS

POWER I does not require special treatment in excess of the usual care taken with

high quality devices. Clean the housing with a dry or slightly moistened cloth. Please do not use any

aggressive detergents or detergents which contain silicon.

The best way to clean the chromed front plate is with a mild non-aggressive fat-dissolving detergent (e.g.

glass cleaner). Use a very soft clean cloth and wipe the front plate with this without exerting strong

pressure. Never use abrasive agents or polishing agents with abrasive particles.

IMPORTANT!

Do not place the unit in direct sunshine and avoid extreme changes in

temperature.

9. Troubleshooting

Malfunctions are mostly caused by something simple which can be put right quickly.

In the next section some possible malfunctions are described together with their corrective action.

However, if it is not possible to remove the malfunction please contact your authorized dealer.

Malfunction

The unit was switched on, the display remains dark.

Cause 1

The mains cable is not properly connected.

Solution

Check mains cable and push in firmly.

Cause 2

The FUSE 2 is damaged.

Solution

Pull out the mains plug and replace the corresponding fuse (see chapter

Malfunction

The POWER I does not play

Cause

A fuse inside the unit is damaged.

Solution

Pull out the mains plug, carefully remove the housing cover and replace the respective

fuse. This replacement action must be carried out by the authorized dealer.

Cause 2

Clipping due to overload of the power amplifier.

Solution

Lower the volume by turning the rotary control 10 to the left

5. 8