FIAT PRODUCTS L-7 Assembly Instructions

Browse online or download pdf Assembly Instructions for Bathroom Fixtures FIAT PRODUCTS L-7. FIAT PRODUCTS L-7 2 pages. Laundry tubs

Print Page

FIGURE 1

1. Drill out plastic filler panel hole on the back of the

tub skirt and insert tab (A) into the slot under the

rim. Push the anchoring barb (B) into the hole in

the tub skirt. Repeat for opposite panel.

NOTE: Each of the filler panels are marked L or R

and should be installed accordingly.

2. When mounting tub to a stud wall, install wood

blocking to bridge the studs.

OPTIONAL EQUIPMENT

A-6 LAUNDRY TUB COVER

A2. OVERFLOW

TUBE

ASSEMBLY INSTRUCTIONS

for LAUNDRY TUBS

WALL MOUNTING PROCEDURE

A3 FAUCET ADAPTER

For top supply connection

faucets

SINGLE TUB

MOUNT BRACKET

FIGURE 2

3. Single tub units use a single hanger bracket and

Double tub units use two hanger brackets.

Fasten the mounting bracket(s) to the wall at

33 1/8" up from floor with 1/4" lag screws. Make

sure screws drive into studs or blocking. Two

screws must be placed in the outermost holes of

the bracket to properly attach the tub to the wall.

4. Lift and place sink over wall mounting bracket(s).

Make sure tub is seated securely on the lip of the

mounting bracket(s). See DETAIL C.

o:=mm---�- .\=)

DETAIL D

To fasten wall mounting bracket to concrete

or cement block wall construction, follow the

same procedure for wood stud walls discussed

above.

Drill holes with a masonry bit and use lead alloy

screw anchors with 1/4" lag screws and flat

washers.

MODEL L-1

MODEL L-7

MODEL SF1-W

MODEL LTD II

DETAIL C

. ..

• • � •

: : ,d� .

. ..

•

: . .

·,