FIBARO ROLLER SHUTTER 3 Manual - Page 10

Browse online or download pdf Manual for Controller FIBARO ROLLER SHUTTER 3. FIBARO ROLLER SHUTTER 3 18 pages.

Print Page
FIBARO ROLLER SHUTTER 3 Manual
Group Number Maximum Nodes
1
1
2
5
3
5

Configuration Parameters

Z-Wave products are supposed to work out of the box after inclusion, however certain
configuration can adapt the function better to user needs or unlock further enhanced features.
IMPORTANT: Controllers may only allow configuring signed values. In order to set values in
the range 128 ... 255 the value sent in the application shall be the desired value minus 256. For
example: To set a parameter to 200 it may be needed to set a value of 200 minus 256 = minus 56.
In case of a two byte value the same logic applies: Values greater than 32768 may needed to be
given as negative values too.
Parameter 20: Switch type
This parameter defines as what type the device should treat the switch connected to the S1 and
S2 terminals.
This parameter is not relevant in gate operating modes (parameter 151 set to 3 or 4). In this case
switch always works as a momentary and has to be connected to S1 terminal.
Size: 1 Byte, Default Value: 2
Setting
0
momentary switches
1
toggle switches
2
single, momentary switch (the switch should be connected to S1 terminal)
Parameter 24: Inputs orientation
This parameter allows reversing the operation of switches connected to S1 and S2 without
changing the wiring.
Size: 1 Byte, Default Value: 0
Setting
0
default (S1 – 1st channel, S2 – 2nd channel)
1
reversed (S1 – 2nd channel, S2 – 1st channel)
Parameter 25: Outputs orientation
Description
Lifeline
Roller Shutter
Slats position control
Description
Description