FIBARO ROLLER SHUTTER 3 Manual - Page 2
Browse online or download pdf Manual for Controller FIBARO ROLLER SHUTTER 3. FIBARO ROLLER SHUTTER 3 18 pages.
Print Page
Z-Wave ensures a reliable communication by
reconfirming every message (two-way
communication) and every mains powered node
can act as a repeater for other nodes (meshed
network) in case the receiver is not in direct
wireless range of the transmitter.
This device and every other certified Z-Wave
device can be used together with any other
certified Z-Wave device regardless of brand
and origin as long as both are suited for the same frequency range.
If a device supports secure communication it will communicate with other devices secure as
long as this device provides the same or a higher level of security. Otherwise it will
automatically turn into a lower level of security to maintain backward compatibility.
For more information about Z-Wave technology, devices, white papers etc. please refer to
www.z-wave.info.
Product Description
FIBARO Roller Shutter 3 is a device designed to control roller blinds, awnings,
venetian blinds, gates and other single phase, AC powered devices.
Roller Shutter 3 allows precise positioning of roller blinds or venetian blind lamellas.
The device is equipped with power and energy monitoring. It allows to control
connected devices either via the Z-Wave network or via a switch connected directly to it.
Prepare for Installation / Reset
Please read the user manual before installing the product.
In order to include (add) a Z-Wave device to a network it must be in factory default state.
Please make sure to reset the device into factory default. You can do this by performing an
Exclusion operation as described below in the manual. Every Z-Wave controller is able to
perform this operation however it is recommended to use the primary controller of the previous
network to make sure the very device is excluded properly from this network.
Reset to factory default
This device also allows to be reset without any involvement of a Z-Wave controller. This
procedure should only be used when the primary controller is inoperable.
1. Press and hold the B-button to enter the menu.