Digisol DG-GS4526P Installation Manual - Page 17

Browse online or download pdf Installation Manual for Switch Digisol DG-GS4526P. Digisol DG-GS4526P 18 pages. 22 port 10/100/1000mbps layer 2 poe switch with 4 gc ports

Print Page

Fiber cables should be connected as below:

Step 1: remove the protective plug from the SFP/XFP fiber transceiver bore; Remove the

protective cap from one end of the fiber cable. Keep the fiber end clean and neat.

Step 2: Attach one end of the fiber cable to the SFP/XFP transceiver, and attach the

other end to the transceiver of the other devices. Note: SFP/XFP transceiver's TX port

should be connected to RX port of other device, and SFP/XFP transceiver's RX port

should be connected to TX port of other device.

Step 3: Check the fiber port status indicator, a light LED indicates that the link has been

established; otherwise the link is not ready and should be examined.

Caution!

Please verify the sign above the port to ensure using the other ports. Connecting to wrong

ports might damage the transceiver or the other ports. When connecting other devices

through a fiber cable to the switch, the output power of the fiber cable must not exceed the

maximum received power of the corresponding modules. Otherwise, it will damage the

switch. Do not stare at the fiber bore when the switch is in operation. That may hurt your

eyes.

2.3.5 Power Supply Connection

DG-GS4526P use 220V AC power. Please read the power input specification for the

detailed information.

Power supply connection procedure is described as below:

Fig 2-4 Attaching power cable to DG-GS4526P

DG-GS4526P Installation Guide