Digisol DG-GS4600SE2 Series Installation Manual - Page 17

Browse online or download pdf Installation Manual for Switch Digisol DG-GS4600SE2 Series. Digisol DG-GS4600SE2 Series 20 pages. Giga layer 3 switches

Digisol DG-GS4600SE2 Series Installation Manual
DG-GS4600SE2series provides a Mini-USB serial console port.
The connection procedure is shown below:
1.
Find the console cable provided in the accessory kit. Attach the Mini-USB end to
console port of the switch.
2.
Connect the other side of the console cable to a character terminal (PC).
3.
Power on the switch and the character terminal. Configure the switch through the
character terminal.

2.3.3 SFP Transceiver Installation

DG-GS4600SE2 series provide multiple 1000Mb SFP transceiver slots.
The procedure for installing SFP transceiver is shown below:
Step 1: Put on a ESD wrist strap (or antistatic gloves).
Step 2: Insert SFP transceiver to the guide rail inside the fiber interface line card. Do not
put the SFP transceiver up-side-down.
Step 3: Push SFP transceiver along the guide rail gently until you feel the transceiver snap
into place at the bottom of the line card.
Note: SFP transceiver supports the hot swap.
Caution!
Do not stare directly at the 2 fiber bores in the SFP transceiver when the switch is in
operation, otherwise the laser may hurt your eyes.
Fig 2- 2 Connecting Console to switch
Chapter 2-7
DG-GS4600SE2 Installation Guide