Sharp Carousel R-1872 Installation Manual - Page 4

Browse online or download pdf Installation Manual for Microwave Oven Sharp Carousel R-1872. Sharp Carousel R-1872 9 pages. Over-the-range microwave oven/hood system
Also for Sharp Carousel R-1872: Operation Manual (32 pages), Brochure & Specs (8 pages), Installation Instructions Manual (8 pages)

Print Page

Sharp Carousel R-1872 Installation Manual

8 PREPARATION OF THE OVEN

1. Rest the oven on its side as shown in Figure 7. Place portion (C)

of the carton underneath to protect the outercase from being

damaged.

2. Remove the two screws which secure the mounting plate to the

rear side of the oven. Remove the mounting plate. The two

screws can be discarded.

NOTE: If the unit you purchased does not have the mounting plate

attached to the rear side of the oven, please disregard this section

and continue to Section 9.

9 VENTILATION SYSTEM

This Microwave Oven/Hood System is designed for adaptation to

three types of hood ventilation systems. Select the type required for

your installation.

A. RECIRCULATING — Non-Vented, Ductless Operation

The unit is shipped assembled for recirculating.

NOTE:

1. The Exhaust Damper Assembly is not required for recir-

culating operation.

2. The Charcoal Filter should be replaced every 6 to 12

months, depending on use.

3. The Charcoal Filter RK-220 is also sold as an accesso-

ry. See Operation Manual for ordering information.

B. HORIZONTAL EXHAUST — Outside Ventilation

1. Remove and save the 4 screws from Fan Cover

Bracket. Remove Fan Cover Bracket by sliding it in the

opposite direction of the arrow on the Fan Cover

Bracket, as shown in Figure 8.

2. Lift Hood Fan Unit carefully and slip wires out of cavity.

See Figure 9.

CAUTION: Do not pull or stretch hood fan wiring.

3. Rotate the Hood Fan Unit 180˚ so that the fan blade

openings are facing the back of the oven. Note, you will

need to lift the wire over the hood fan unit so the wire will

clear. See Figure 10 (A). Replace Hood Fan Unit into the

oven. Be careful not to pinch the wire and the Hood Fan

Unit. See Figure 10 (B).

4. Put the wire back into the cavity.

5. Replace the fan cover bracket. Make sure the fan blades

are visible through the rear openings in oven before pro-

ceeding. Attach the fan cover bracket to the unit with the

4 screws removed in step 1 above. See Figure 11. The

hood fan is now rotated for horizontal exhaust operation.

6. Attach the Exhaust Damper Assembly to the back of the

mounting plate by sliding it into the slits in the same

direction as the arrow. See Figure 12. Using tapping

screw 4 x 12 mm from the INSTALLATION HARD-

WARE, tighten into place.

Figure 7

Mounting plate

Grease filter openings

Fan Cover Bracket

(A) Rotate 180˚

(B)

Figure 10

Figure 8

Figure 9