Sharp Carousel R-307K Operation Manual - Page 6

Browse online or download pdf Operation Manual for Microwave Oven Sharp Carousel R-307K. Sharp Carousel R-307K 25 pages. Operation manual
Also for Sharp Carousel R-307K: Operation Manual (25 pages)

Print Page

Unpacking and Examining Your Oven

Remove:

1. all packing materials from inside the oven cav-

ity;

however,

NOT

REMOVE

THE

WAVEGUIDE COVER, which is located on the

right cavity wall. Read

_afety door lalches

m/enclosures

and SAVE

[')the Operation Manual.

III _1(2. the feature sticker, if

_L[

JJ_I')there

is one, from the

_ outside of the door.

_( Check the oven for any

De_'Jorsealsand

Waveguide_damage, such as mis-

Ning

sealingsulfaces

cover

aligned

or bent door,

damaged

door seals

and sealing surfaces, broken or loose door hinges

and latches and dents inside the cavity or on the

door. If there is any damage, do not operate the

oven and contact your dealer or SHARP

AUTHORIZED

SERVICER.

Choosing

a Location for Your Oven

You will use the oven frequently so plan its loca-

tion for ease of use. It's wise, if possible, to have

counter space on at least one side of the oven.

Allow at least 2 inches (50 mm) on the sides, top

and at the rear of the oven for air circulation. Do

not place or install the oven in any area where

heat and steam are generated; for example, next

to or above a conventional

gas or electric range

or above a conventional

wall oven. Heat and

steam may damage the electronics

or the me-

chanical parts of the oven.

This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a

grounding plug. It must be plugged into a wall receptacle that is properly installed and grounded in

accordance with the National Electrical Code and local codes and ordinances. In the event of an electri-

cal short circuit, grounding reduces risk of electric shock by providing an escape wire for the electric

current.

WARNING

- Improper use of the grounding plug can result in a risk of electric shock.

Electrical

Requirements

The electrical requirements are a 120 volt 60 Hz, AC only, 15 amp. or more

protected electrical supply. It is recommended that a separate circuit serv-

ing only this appliance be provided.

The oven is equipped with a 3-prong grounding plug. It must be plugged

into a wall receptacle that is properly installed and grounded. Should you

only have a 2-prong outlet, have a qualified electrician install a correct wall

receptacle.

A 3-prong adapter may be purchased and used temporarily if local codes

allow. Follow package directions.

A short power-supply cord is provided to reduce risk of becoming entangled

in or tripping over a longer cord.

Permanent

and Correct

_nstaiiation

3-Prong P:ug

3-Prong Receptac:e _¢_

Ground "/

Receptac:e Box

Temporary

Use

ExtensionCord

If it is necessary to use an extension cord, use only a 3-wire extension cord

that has a 3-blade grounding plug and a 3-slot receptacle that will accept

the plug on the microwave oven. The marked rating of the extension cord

should beAC 115-120 volt, 15 amp. or more.

Be careful not to drape the cord over the cou ntertop or table where it can be

pulled on by children or tripped over accidentally.

Notes: 1. If you have any questions about the grounding or electrical in-

structions, consult a qualified electrician or service person.

2. Neither Sharp nor the dealer can accept any liability for damage

to the oven or personal injury resulting from failure to observe the

correct electrical connection procedures.

Ground

Glound]ng

Receptac:e

BOX

Adapter

Radio or TV Interference

Should there be any interference caused by the microwave oven to your radio or TV, check that the

microwave oven is on a different electrical circuit, relocate the radio or TV as far away from the oven as

feasible or check position and signal of receiving antenna.