Sharp Carousel R-326FS Service Manual - Page 24

Browse online or download pdf Service Manual for Microwave Oven Sharp Carousel R-326FS. Sharp Carousel R-326FS 44 pages. Sharp operation manual microwave oven r-326fs
Also for Sharp Carousel R-326FS: Operation Manual (24 pages)

Print Page
R - 326FS
LSI
The I/O signal of the LSI is detailed in the following table.
Pin No.
Signal
1-2
P26-P27
OUT
3-5
P70-P72
OUT
6
IC
7
X2
OUT
8
X1
9
VDD1
10
XT1
11
XT2
OUT
12
RESET
13
INTP0
14
INTP1
15
P02
OUT
16
P03
OUT
17
P04
OUT
18
P05
OUT
19
P110
OUT
20
P111
OUT
21
P112
OUT
22
P113
OUT

DESCRIPTION OF LSI

I/O
Terminal not used.
Terminal not used.
IN
Connected to VC.
Internal clock oscillation output.
Output to control oscillation input to X2.
IN
Internal clock oscillation frequency control input setting.
The internal clock frequency is set by inserting the ceramic filter oscillation circuit with
respect to X1.
IN
Power source voltage: GND(0V).
The power source voltage to drive LSI is input to VDD1 terminal.
IN
Connected to GND.
Terminal not used.
IN
Auto clear terminal.
Signal is input to reset the LSI to the initial state when power is applied.
IN
Connected to VC.
IN
Signal synchronized with commercial power source frequency.
This is the basic timing for time processing of LSI.
Terminal not used.
Magnetron high-voltage circuit driving signal.
To turn on and off the cook relay (RY2). The
signals holds "L" level during microwave
cooking and "H" level while not cooking. In
other cooking modes (variable cooking) the
signal turns to "H" level and "L" level in
repetition according to the power level.
Oven lamp, fan motor and turntable motor driving signal
To turn on and off shut off relay (RY1). The
square waveform voltage is delivered to the
RY1 driving circuit and RY2 control circuit.
Terminal not used.
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to ANI7, P100, P101, P102
and P103 terminal while one of G8 line keys on key matrix is touched.
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to ANI7, P100, P101, P102
and P103 terminal while one of G7 line keys on key matrix is touched.
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to ANI7, P100, P101, P102
and P103 terminal while one of G6 line keys on key matrix is touched.
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to ANI7, P100, P101, P102
and P103 terminal while one of G5 line keys on key matrix is touched.
Description
Maximum
output
70% of maximum
output
22
H : GND
L : -5V
16.7 msec.
OFF
H : GND
ON
L : -5V
OFF
OFF
H : GND
24 sec.
8 sec.
ON
L : -5V
16.7 msec.
H : GND
L : -5V
During cooking