Sharp Carousel R-326FS Service Manual - Page 34

Browse online or download pdf Service Manual for Microwave Oven Sharp Carousel R-326FS. Sharp Carousel R-326FS 44 pages. Sharp operation manual microwave oven r-326fs
Also for Sharp Carousel R-326FS: Operation Manual (24 pages)

Print Page

R - 326FS

9. Release door panel from eight (8) tabs of door frame.

10.Now, door panel with sealer film is free.

11.Tear sealer film from door panel.

12.Now, door panel is free.

13.Slide latch head upward and remove it from door frame

with releasing latch spring from door frame and latch

head.

14.Now, latch head and latch spring are free.

15.Remove door screen from door frame.

16.Now, door screen is free.

17.Unfold each eleven (11) tab of the door decoration upper

and lower by using a pair of needle-nose pliers. Now the

door frame is loose.

REINSTALLATION

1. Insert each eleven (11) tab of the door decoration upper

and lower into each slit of the door frame by using a pair

of needle-nose pliers.

2. Reinstall door screen to door frame .

3. Reinstall the latch spring to the latch head. Reinstall the

latch spring to the door frame. Reinstall latch head to

door frame.

4. Reinstall door panel to door frame by fitting eight (8) tabs

of door frame to eight (8) holes of door panel.

5. Put sealer film on door panel. Refer to "Sealer Film"

about how to handle new one.

6. Catch two (2) pins of door panel on two (2) hole of upper

and lower oven hinges.

7. Reinstall choke cover to door panel by pushing.

Note: After any service to the door;

(A) Make sure that door sensing switch and secondary

interlock switch are operating properly. (Refer to

chapter "Test Procedures".).

(B) An approved microwave survey meter should be

used to assure compliance with proper microwave

radiation emission limitation standards.

After any service, make sure of the following :

1. Door latch heads smoothly catch latch hook through

latch holes and that latch head goes through center of

latch hole.

2. Deviation of door alignment from horizontal line of cavity

face plate is to be less than 1.0mm.

3. Door is positioned with its face pressed toward cavity

face plate.

4. Check for microwave leakage around door with an

approved microwave survey meter. (Refer to Microwave

Measurement Procedure.)

Note: The door on a microwave oven is designed to act as

an electronic seal preventing the leakage of

microwave energy from oven cavity during cook

cycle. This function does not require that door be air-

tight, moisture (condensation)-tight or light-tight.

Therefore, occasional appearance of moisture, light

or sensing of gentle warm air movement around

oven door is not abnormal and do not of themselves

indicate a leakage of microwave energy from oven

cavity.

Upper

Oven Hinge

Slit choke of

door panel

Lower Oven

Hinge

Figure C-5. Door Replacement

SEALER FILM

Installation

1. Put the adhesive tape on the backing film of the sealer

film as shown in Fig. C-6.

2. Tear the backing film by pulling the adhesive tape.

3. Put the pasted side of the sealer film on the door panel

Sealer film

Figure C-6. Sealer film

Upper Oven

Hinge

Lower

Oven Hinge

Choke Cover

Backing film

Adhesive tape