Sharp Aquos LC-19D1E Operation Manual - Page 17

Browse online or download pdf Operation Manual for LCD TV Sharp Aquos LC-19D1E. Sharp Aquos LC-19D1E 32 pages. Aquos lcd colour television

Print Page

Menu operations

PC Setup

For adjusting a PC image.

• Only "H-Pos." and "V-Pos." in "Fine Sync." are available

when the HDMI-PC input (see page 1) is selected.

Input Signal

Menu Operation: C (page 9)

Some input signals may have to be registered manually

to display properly.

The input signals (resolutions) in the list below are not

distinguishable when received. In such case, you have to

set the correct signal manually. After setting once, it will

display when the same signal (resolution) is input again.

640 g 400

640 g 480

1024 g 768

1280 g 768

NOTE

• Depending on the graphics card, resolution of 1360 x 768

may not display correctly.

• You can only select the "Input Signal" on the Setup menu

when receiving one of the 7 input signals listed above.

• The above list will display in accordance with vertical

resolution of input signals.

Auto Sync.

Menu Operation: C (page 9)

For automatically adjusting the PC image.

Item

Yes: Auto Sync. starts.

No: You have to set Fine Sync. later.

NOTE

• Auto Sync. is likely to succeed when an input PC image

has wide vertical stripes (ex. pattern with high contrast

stripes, or cross-hatched).

• It may fail when an input PC image is solid (low contrast).

• Be sure to connect the PC to the LCD-TV and switch it on

before starting Auto Sync.

Fine Sync.

Menu Operation: C (page 9)

Ordinarily, the TV automatically adjusts image positions coming

from PC (Auto Sync. function). In some cases, however, manual

adjustment is needed to optimise the image.

Item

H-Pos.: Centres the image by moving it to the left or right.

V-Pos.: Centres the image by moving it up or down.

Clock: Adjusts when the image flickers with vertical

stripes.

Phase: Adjusts when characters have low contrast or

when the image flickers.

NOTE

• If you need to adjust the image position, adjust the position

using your PC.

• "Clock" and "Phase" cannot be adjusted when the HDMI-

PC input (see page 1) is selected.

PC only

720 g 400

848 g 480

1360 g 768

PC only

HDMI Audio Select

Menu Operation: A (page 9)

Select "Digital" for audio signal via the HDMI terminal.

Select "Analogue" for audio signal via the AUDIO jack.

NOTE

• This function is only available when "EXT4" is selected in

the INPUT SOURCE menu.

HDMI Auto View

Menu Operation: A (page 9)

Set whether or not to use WIDE MODE based on signal

recognition, including an HDMI signal.

NOTE

• This function is only available when "EXT4" is selected in

the INPUT SOURCE menu.

WSS (Wide Screen Signalling)

Menu Operation: A (page 9)

WSS allows a television to switch automatically among

the different screen formats.

NOTE

• Use WIDE MODE if an image does not switch to the correct

screen format. When the broadcast signal contains no

WSS information, the function will not work even if enabled.

(See page 17.)

4:3 Mode

Menu Operation: A (page 9)

The WSS signal has 4:3 auto-switching that allows you

to select between Normal and Panorama.

Item

Panorama: Wide image without side bars

Normal: Normal range keeping 4:3 or 16:9 aspect ratio

WSS signal 4:3 screen

4:3 mode "Normal"

TV/DTV/AV only

4:3 mode "Panorama"