Fiber Tronix FT-FOTR-16VD-ST-S Installation Manual - Page 4

Browse online or download pdf Installation Manual for Transceiver Fiber Tronix FT-FOTR-16VD-ST-S. Fiber Tronix FT-FOTR-16VD-ST-S 5 pages. 16-channel digital duplex baseband video transmitter and receiver with reverse data transmission for ptz cameras

Print Page
Digital Video Optical System
Power
Data Tx
Optical
Data Rx
a. Plug the included power supplies in a 120VAC outlet. Each power supply's DC output
adaptor connects respectively to the power input of the transmitter and receiver.
b. Connect the transmitter and receiver's optical connectors with an ST/PC patch cable.
The transmitter and receiver's Link Indicator Lights will indicate optical signals are
transmitted and received normally.
c. Connect the video source (e.g., camera) to the transmitter's video input port using
quality 75Ω coaxial cable with BNC connectors.
d. Connect the video monitor to the receiver's video output port using quality 75Ω coaxial
cable with BNC connectors.
e. Connect the data ports using the RS485 terminal block. Be sure the wiring
configurations are consistent with the diagram above for the transmitter and receiver
as well as the PTZ camera.
f.
Indicator lights:
Power LEDs display power status. A normal display indicates the input
power supply is correct. An irregular display indicates the wrong input power
or a problem with the unit's circuits.
Optical LEDs display whether the optical signals are being transmitted and
received correctly.
Video Signal LEDs indicate the video status
Data TX and Data RX LEDs respectively display data output and data input
status.
v1.0 4/5/11
Receiver Front and Rear Panels
Video Signal Indicators
1
2
3
4
5
6
7
8
9 10 11 12
13
14 15 16
Terminal Block
A: Data Output +
B: Data Output –
G: Ground Connection
Optical port
（ST/PC）
CH9
CH10 CH11
OPTICAL
POWER
CH1
CH2
CH3
Power Input
Video Output 1-16 ch
（DC5V）
RS485
A B G
Data
4
Data connector
(Terminal Block)
CH12 CH13
CH14
CH15 CH16
A
BG
Data
CH4
CH5
CH6
CH7
CH8