DIGISYSTEM AFV2000 Instruction Manual - Page 7
Browse online or download pdf Instruction Manual for Power Supply DIGISYSTEM AFV2000. DIGISYSTEM AFV2000 9 pages. Variable frequency vibrators power supply
Also for DIGISYSTEM AFV2000: Instruction Manual (9 pages), Instruction Manual (9 pages)
Print Page
PROBLEMS SOLUTION
fault
Led DL2 switches regularly on and off
At power on the led DL2 doesn't switch
momentary on and DL1 doesn't switches
at all
At power on the led DL1 is off and led
DL2 switches momentary on, but
vibration doesn't start
At power on the led DL1 switches on
and led DL2 switches momentary on,
but vibration doesn't start
If actions remarked on the table doesn't resolve the problem you may contact factory
digisystem srl (e-mail
OPENING INSTRUCTIONS
As on the electronic card there are some capacitors with high voltage applied (presence of
residuary energy, danger of strike) you must wait at least 4 - 5 minutes after the device is
disconnected from the power supply, before opening the box.
Remove the four screws on the panel.
functional
anomaly
Overload
Decrease reference voltage to
condition
Device not
Verify mains supply and input
supplied
fuses; to locate fuses F1 see
instructions to open the device
There is not
Place switch SW2 to on or send
start command
a start command from input
Vibrator not
supplied
problem is not there may be
there is a failure on drivers into
) we will help you.
7
What to do
decrease the output power
cable
Check wiring from power
supply to vibrator; if the
the power supply