Sharp CD-BA2600H Operation Manual - Page 31

Browse online or download pdf Operation Manual for Stereo System Sharp CD-BA2600H. Sharp CD-BA2600H 42 pages. Mini component system
Also for Sharp CD-BA2600H: Operation Manual (5 pages)

Print Page

1. Speaker System

„ To set the internal clock by the RDS time

signal

You can set the internal clock using the RDS time signal (RDS CT data). This is use-

ful because the internal clock is set automatically from the time signal sent by an

RDS station.

Before setting, select one of the 24-hour or 12-hour display as shown on page 11.

Tune in to an RDS station (when its name is displayed).

Press the DISPLAY MODE button to select CT.

(Example: 11:56 on April 30, 2001)

For 3 seconds

Whilst RDS time is displayed, hold down the CLOCK button for at

least 3 seconds.

"RDS TIME" and "WAITING" will appear alternately. Wait until "COMPLETE" ap-

pears. (It will appear in less than 60 seconds.)

After the internal clock has been set, "COMPLETE" will be dis-

played for 3 seconds. Then the updated time will be displayed.

Press the CLOCK button to check whether the internal clock is displaying the

same time as the RDS clock.

Notes:

z When the CLOCK button is pressed whilst the RDS time is displayed, the internal

clock is displayed followed by the RDS clock. With this feature, you can compare

the time shown. If you have not yet set the clock display mode, "CLOCK" will

appear.

z Whilst "NO CT" or "CT" is displayed, the internal clock cannot be set.

z If the signal from a station is weak or noisy, you may not be able to set the internal

clock.

Note for clock-time and date mode:

When the DISPLAY MODE button is pressed repeatedly to select CT, the data

(Day-Month-Year) will be displayed for 3 seconds, and then the RDS clock time

display will appear.

The RDS clock time appears with "RDS", so that you will know it is not the internal

clock time.

Notes:

z If you tune in to an RDS station which is not sending clock-time and date (CT data)

and you select CT, "NO CT" will be displayed.

z If you are not receiving CT data, even though you are tuned into an RDS station,

"CT" will be displayed. The CT data is sent at the top of each minute.

z If an RDS signal is weak or noisy, the clock time may be displayed as "- -"

(hyphens) or it may not be displayed correctly.

RDS clock time

z You must check the clock's accuracy because the RDS time signal (CT data) may

not be correct, depending on the station.

z The data normally changes at midnight, Greenwich Mean Time (G.M.T.), not local

time.

ENGLISH

E-25