Sharp CD-BA300 Operation Manual - Page 5

Browse online or download pdf Operation Manual for Stereo System Sharp CD-BA300. Sharp CD-BA300 32 pages. Cdba300 operation manual
Also for Sharp CD-BA300: Quick Manual (4 pages)

Print Page

Precautions

General

Please ensure that the equipment is positioned in a well ventilated area and

ensure that there is as least 4" (10 cm) of free space along the sides, top and

back of the unit.

4" (10 cm)

Use the unit on a firm, level surface free from vibration.

Keep the unit away from direct sunlight, strong

magnetic fields, excessive dust, humidity and elec-

tronic/electrical equipment (home computers, fac-

similes, etc.) which generates electrical noise.

Do not place anything on top of the unit.

Do not expose the unit to moisture, to temperatures higher than 140 F (60 C)

or to extreme low temperatures.

If your system does not work properly, disconnect the AC power cord from the

AC outlet. Plug the AC power cord back in, and then turn on your system.

In case of an electrical storm, unplug the unit for safety.

Hold the AC power plug by the head when removing it

from the AC outlet, as pulling the cord can damage

internal wires.

Do not remove the outer cover, as this may result

in electric shock. Refer internal service to your lo-

cal SHARP service facility.

This unit should only be used within the range of 41 F - 95 F (5 C - 35 C).

*BA300_P04_09

Warning:

The voltage used must be the same as that specified on this unit.

Using this product with a higher voltage other than that which is specified is dan-

gerous and may result in a fire or other type of accident causing damage. SHARP

will not be held responsible for any damage resulting from use of this unit with a

voltage other than that which is specified.

4" (10 cm)

The sound level at a given volume setting depends on speaker efficiency, location

4" (10 cm)

and various other factors.

It is advisable to avoid exposure to high volume levels, which occur while turning

the unit on with the volume control setting up high, or while continually listening at

high volumes.

Compact discs are fairly resistant to damage, however mistracking can occur due

to an accumulation of dirt on the disc surface.

Follow the guidelines below for maximum enjoyment from your CD collection and

player.

Volume control

Care of compact discs

Do not write on either side of the disc, particularly the non-label side from

which signals are read.

Do not mark this surface.

Keep your discs away from direct sunlight, heat, and excessive moisture.

Always hold the CDs by the edges. Fingerprints, dirt, or water on the CDs can

cause noise or mistracking. If a CD is dirty or does not play properly, clean it

with a soft, dry cloth, wiping straight out from the center, along the radius.

00.11.16, 2:47 PM

YES

correct