Sharp CD-DK890N Operation Manual - Page 40

Browse online or download pdf Operation Manual for Stereo System Sharp CD-DK890N. Sharp CD-DK890N 44 pages. Mini component system
Also for Sharp CD-DK890N: Quick Start Manual (2 pages)

Print Page
Sharp CD-DK890N Operation Manual
Enhancing your system (continued)
CD-DK890N
Auto power on function:
When you press any of the following buttons, the unit turns on.
AUDIO IN button (main unit and remote control): The unit turns on
and the "AUDIO IN" function is activated.
/
button on the main unit: The unit turns on and playback of
the last function starts (CD, TAPE, TUNER, AUDIO IN).
To record on a tape from VCR, etc.
1
Insert a cassette in the TAPE 2 cassette compartment.
2
Press the AUDIO IN button.
3
Press the
button.
4
Press the
/
5
Start the system, VCR, etc.
Headphones
Before plugging in or unplugging the headphones, reduce the
volume.
Be sure your headphones have a 1/8" (3.5 mm) diameter plug and
impedance between 16 and 50 ohms. The recommended
impedance is 32 ohms.
Plugging
in
the
automatically. Adjust the volume using the VOLUME control.
40
(TAPE
) button.
headphones
disconnects
5
4
3
2
1
TIMER
CD
PLAYBACK (PLAY & STOP)
AUDIO
PHONES
IN

Troubleshooting chart

Many potential problems can be resolved by the owner without
calling a service technician.
If something is wrong with this product, check the following before
calling your authorized SHARP dealer or service center.
General
Symptom
The clock is not set to the
correct time.
When a button is pressed,
the unit does not respond.
No sound is heard.
CD player
Symptom
the
speakers
Playback does not start.
Playback stops in the
middle or is not performed
properly.
Playback sounds are
skipped, or stopped in the
5
4
middle of a track.
3
2
1
RECORD/PLAYBACK
Possible cause
Did a power failure occur? Reset
the clock. (Refer to page 15.)
Set the unit to the power stand-
by mode and then turn it back on.
If the unit still malfunctions, reset
it. (Refer to page 42.)
Is the volume level set to "0"?
Are the headphones connected?
Are the speaker wires
disconnected?
Possible cause
Is the disc loaded upside down?
Does the disc satisfy the
standards?
Is the disc distorted or
scratched?
Is the unit located near excessive
vibrations?
Is the disc very dirty?
Has condensation formed inside
the unit?